BLKDQ57TM Intel (CPU), BLKDQ57TM Datasheet - Page 60

• Manufacturer Part Number: BLKDQ57TM
• Manufacturer: Intel (CPU)

Specifications of BLKDQ57TM

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Clearing Passwords in the BIOS Setup
Program
60
The three-pin BIOS jumper block enables board configuration to be done in the BIOS
Setup program. Table 16 shows the jumper settings for the BIOS Setup program
modes.
Table 16. Jumper Settings for the BIOS Setup Program Modes
This procedure assumes that the board is installed in the computer and the
configuration jumper block is set to normal mode.
1. Observe the precautions in "Before You Begin" on page 33.
2. Turn off all peripheral devices connected to the computer. Turn off the computer.
3. Remove the computer cover.
4. Find the configuration jumper block (see Figure 27).
5. Place the jumper on pins 2-3 as shown below.
6. Replace the cover, plug in the computer, turn on the computer, and allow it to
7. The computer starts the Setup program. Setup displays the Maintenance menu.
8. Use the arrow keys to select Clear Passwords. Press <Enter> and Setup displays a
9. Press <F10> to save the current values and exit Setup.
Jumper Setting
press <Enter>. Setup displays the maintenance menu again.
Disconnect the computer’s power cord from the AC power source (wall outlet or
power adapter).
boot.
pop-up screen requesting that you confirm clearing the password. Select Yes and
Mode
Normal (default) (1-2)
Configure (2-3)
Recovery (None)
Description
The BIOS uses the current configuration and
passwords for booting.
After the Power-On Self-Test (POST) runs, the
BIOS displays the Maintenance Menu. Use this
menu to clear passwords.
The BIOS recovers data in the event of a failed
BIOS update.