BLKDQ57TM Intel (CPU), BLKDQ57TM Datasheet - Page 61

• Manufacturer Part Number: BLKDQ57TM
• Manufacturer: Intel (CPU)

Specifications of BLKDQ57TM

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Clearing CMOS Memory
10. Turn off the computer. Disconnect the computer’s power cord from the AC power
11. Remove the computer cover.
12. To restore normal operation, place the jumper on pins 1-2 as shown below.
13. Replace the cover, plug in the computer, and turn on the computer.
CAUTION
Initiating a CMOS clear while the board is powered on or in standby mode may
damage the board.
The Desktop Board provides a Clear CMOS jumper block that can be used to clear its
CMOS memory. Figure 28 shows the location of the jumper block; Table 17 shows the
jumper settings. To clear CMOS memory:
1. Observe the precautions in "Before You Begin" on page 33.
2. Turn off all peripheral devices connected to the computer. Turn off the computer.
3. Remove the computer cover.
4. Find the Clear CMOS jumper block (see Figure 28).
5. To clear the CMOS memory, place a jumper (not included) on pins 1 and 2 for at
6. Remove the jumper and reassemble the computer.
7. Turn on the computer, allow it to boot and then enter BIOS Setup or turn off the
Table 17. Clear CMOS Jumper Settings
Jumper
1-2
2-3
None
source.
least 2 seconds.
computer when the splash screen appears. The CMOS settings are returned to
factory defaults.
Mode
Clear
N/A
Normal
Description
The CMOS memory is erased at the next
system boot and returned to factory defaults.
N/A
The BIOS uses the current contents of the
CMOS memory.
61