103308-8 TE Connectivity, 103308-8 Datasheet - Page 5

• Manufacturer Part Number: 103308-8
• Description: Conn Shrouded Header HDR 40 POS 2.54mm Solder ST Thru-Hole
• Manufacturer: TE Connectivity
• Type: Shrouded Headerr

Specifications of 103308-8

• Pitch: 2.54 mm
• Number Of Rows: 2
• Number Of Contacts: 40
• Gender: HDR
• Contact Plating: Gold Over Nickel/Gold Over Palladium Nickel
• Termination Method: Solder
• Product Line: AMP-LATCH
• Profile: Low
• Pcb Mounting Orientation: Vertical
• Pcb Mount Retention: Without
• Mating Connector Lock: Without
• Housing Style: 4-Sided
• Ejection Latches: Without
• Post Size (mm [in]): 0.64 [.025]
• Shrouded: Yes
• [shrouded] End Dimension (mm [in]): 3.81 [0.150]
• Current Rating (a): 1
• Insulation Resistance (m?): 5,000
• Termination Post Length (mm [in]): 3.05 [0.120]
• Solder Tail Contact Plating: Tin-Lead over Nickel
• Header Type: Pin Header
• Number Of Positions: 40
• Centerline, Matrix (mm [in]): 2.54 x 2.54 [.100 x .100]
• Daisy Chain: With
• Preloaded: Yes
• Contact Plating, Mating Area, Material: Gold (15), Gold Flash over Palladium Nickel
• Contact Shape: Square
• Contact Base Material: Copper Alloy
• Connector Style: Header - Pin
• Mating Alignment Type: Center, Dual Polarizing Bar
• Mating Alignment: With
• Housing Material: Thermoplastic - GF
• Ul Flammability Rating: UL 94V-0
• Housing Color: Black
• Rohs/elv Compliance: ELV compliant, 5 of 6 Compliant
• Lead Free Solder Processes: Not suitable for lead free processing
• Approved Standards: UL E28476, CSA LR7189
• Operating Temperature (°c): -65 – +105
• Temperature Rating: Standard

4.
4.1.
4.2.
4.3.
4.4.
Rev D
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes affecting form , fit or function are m ade to the product or m anufacturing process, product
assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determ ined by developm ent/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product m eets the requirem ents of Figure 1. Failures
attributed to equipm ent, test setup or operator deficiencies shall not disqualify the product. W hen
product failure occurs, corrective action shall be taken and sam ples resubm itted for qualification.
Testing to confirm corrective action is required before resubm ittal.
Quality Conform ance Inspection
The applicable quality inspection plan will specify sam pling acceptable quality level to be used.
Dim ensional and functional requirem ents shall be in accordance with the applicable product drawing
and this specification.
Sam ple Selection
Connector housings and contacts shall be prepared in accordance with applicable Instruction
Sheets and shall be selected at random from current production. All test groups shall consist of a
m inim um of 6 connectors. Five contact circuits in each connector shall be random ly selected and
identified, unless otherwise specified, these contacts shall be used for all m easurem ents.
Test Sequence
Qualification inspection shall be verified by testing sam ples as specified in Figure 2.
108-40000
5 of 6