5962-8670901XA E2V, 5962-8670901XA Datasheet - Page 13

• Manufacturer Part Number: 5962-8670901XA
• Manufacturer: E2V

Specifications of 5962-8670901XA

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DSCC FORM 2234
APR 97
appendix A.
prior to quality conformance inspection. The following additional criteria shall apply:
4. QUALITY ASSURANCE PROVISIONS
4.1 Sampling and inspection. Sampling and inspection procedures shall be in accordance with MIL-PRF-38535,
4.2 Screening. Screening shall be in accordance with method 5004 of MIL-STD-883, and shall be conducted on all devices
c.
a.
b.
(1) Test condition A, C, or D. The test circuit shall be maintained by the manufacturer under document revision level
(2) T
DEFENSE SUPPLY CENTER COLUMBUS
Burn-in test, method 1015 of MIL-STD-883.
Interim and final electrical test parameters shall be as specified in table II herein, except interim electrical parameter
tests prior to burn-in are optional at the discretion of the manufacturer.
All devices process to an altered item drawing may be programmed either before or after burn-in at the
manufacturer's discretion. The required electrical testing shall include, as a minimum, the final electrical tests for
programmed devices as specified in table II herein.
control and shall be made available to the preparing or acquiring activity upon request. The test circuit shall
specify the inputs, outputs, biases, and power dissipation, as applicable, in accordance with the intent specified in
test method 1015 of MIL-STD-883.
A
MICROCIRCUIT DRAWING
= +125 C, minimum.
COLUMBUS, OHIO 43216-5000
STANDARD
1/
2/
3/
Interim electrical parameters
Final electrical test parameters
Final electrical test parameters
unprogrammed devices
Group A test requirements
Groups C and D end-point
MIL-STD-883 test requirements
(method 5004)
(method 5004) for
programmed devices
(method 5004) for
(method 5005)
electrical parameters
(method 5005)
* PDA applies to subgroups 1 and 7.
Any or all subgroups may be combined with using high
speed testers.
Subgroups 7 and 8 functional tests shall also verify
that no fuses are blown for unprogrammed devices or
that the altered item drawing pattern exists for
programmed devices.
TABLE II. Electrical test requirements.
1
1*, 2, 3, 7*, 8, 9
1*, 2, 3, 7*, 8
1, 2, 3, 7, 8, 9, 10, 11
1, 2, 3, 7, 8
MIL-STD-883, method 5005,
SIZE
A
(in accordance with
Subgroups
table I)
REVISION LEVEL
E
SHEET
5962-86709
13