IS45R16800E-75BLA2 ISSI, Integrated Silicon Solution Inc, IS45R16800E-75BLA2 Datasheet - Page 20
![no-image](/images/manufacturer_photos/0/3/347/issi__integrated_silicon_solution_inc_sml.jpg)
IS45R16800E-75BLA2
Manufacturer Part Number
IS45R16800E-75BLA2
Description
Manufacturer
ISSI, Integrated Silicon Solution Inc
Datasheet
1.IS45R16800E-75BLA2.pdf
(61 pages)
Specifications of IS45R16800E-75BLA2
Lead Free Status / RoHS Status
Compliant
are registered on the positive edge of the clock signal,
CLK). Each of the 33,554,432-bit banks is organized as
IS42/45R81600E, IS42/45R16800E
FUNCTIONAL DESCRIPTION
The 128Mb SDRAMs are quad-bank DRAMs which operate
at 2.5V and include a synchronous interface (all signals
4,096 rows by 512 columns by 16 bits or 4,096 rows by
1,024 columns by 8 bits.
Read and write accesses to the SDRAM are burst oriented;
accesses start at a selected location and continue for
a programmed number of locations in a programmed
sequence. Accesses begin with the registration of an
ACTIVE command which is then followed by a READ or
WRITE command. The address bits registered coincident
with the ACTIVE command are used to select the bank
and row to be accessed (BA0 and BA1 select the bank, A0-
A11 select the row). The address bits A0-A9 (x8); A0-A8 (x16)
registered coincident with the READ or WRITE command
are used to select the starting column location for the
burst access.
Prior to normal operation, the SDRAM must be initial-
ized. The following sections provide detailed information
covering device initialization, register definition, command
descriptions and device operation.
20
Initialization
SDRAMs must be powered up and initialized in a
predefined manner.
The 128M SDRAM is initialized after the power is applied
to V
with DQM High and CKE High.
A 100µs delay is required prior to issuing any command
other than a COMMAND INHIBIT or a NOP.The COMMAND
INHIBIT or NOP may be applied during the 100us period and
should continue at least through the end of the period.
With at least one COMMAND INHIBIT or NOP command
having been applied, a PRECHARGE command should
be applied once the 100µs delay has been satisfied. All
banks must be precharged. This will leave all banks in an
idle state after which at least two AUTO REFRESH cycles
must be performed. After the AUTO REFRESH cycles are
complete, the SDRAM is then ready for mode register
programming.
The mode register should be loaded prior to applying
any operational command because it will power up in an
unknown state.
dd
Integrated Silicon Solution, Inc. — www.issi.com
and V
ddq
(simultaneously) and the clock is stable
04/15/2010
Rev. A