RC28F640J3F75A NUMONYX, RC28F640J3F75A Datasheet - Page 19

• Manufacturer Part Number: RC28F640J3F75A
• Manufacturer: NUMONYX

Specifications of RC28F640J3F75A

• Lead Free Status / RoHS Status: Not Compliant

Numonyx
5.0
5.1
Warning:
Table 4:
5.2
Warning:
Table 5:
5.3
5.3.1
March 2010
208032-02
NOTICE: This document contains information available at the time of its release. The specifications are subject to change without
notice. Verify with your local Numonyx sales office that you have the latest datasheet before finalizing a design.
Temperature under Bias Expanded (T
Storage Temperature
VCC Voltage
VCCQ Voltage
Voltage on any input/output signal (except VCC, VCCQ)
I
Notes:
1.
2.
3.
T
V
V
SH
A
CC
CCQ
Symbol
Output Short Circuit Current
Voltage is referenced to V
output pins may undershoot to –2.0 V for periods < 20 ns or overshoot to V
During infrequent non-periodic transitions, the voltage potential between V
V for periods < 20 ns or V
Output shorted for less than one second. No more than one output pin/ball can be shorted at a time.
®
Embedded Flash Memory (J3 65 nm) Single Bit per Cell (SBC)
Absolute Maximum Ratings
Temperature and V
Operating Temperature
VCC Supply Voltage
VCCQ Supply Voltage
Maximum Ratings and Operating Conditions
Absolute Maximum Ratings
Stressing the device beyond the “Absolute Maximum Ratings” may cause permanent
damage. These are stress ratings only.
Operating Conditions
Operations beyond the “Operating Conditions” is not recommended and extended
exposure beyond the “Operating Conditions” may affect device reliability.
Power-Up/Down
This section provides an overview of system level considerations with regards to the
flash device. It includes a brief description of power-up/down sequence and decoupling
design considerations.
Power-Up/Down Sequence
To prevent conditions that could result in spurious program or erase operations, the
power-up/power-down sequence shown in
characteristics refer to
voltage range before applying/removing the next supply voltage.
Parameter
Parameter
SS
SUPPLY
. During infrequent non-periodic transitions, the voltage potential between V
A
, Ambient)
(max) + 2.0 V for periods < 20 ns.
CC
Operating Condition
Table
-40.0
2.70
2.70
8. Note that each power supply must reach its minimum
Min
+85
3.6
3.6
–2.0
–2.0
–2.0
Min
–40
–65
—
Table 6
Max
is recommended. For DC voltage
CC
CCQ
and the supplies may undershoot to –2.0
°C
V
V
V
(max) + 2.0 V for periods < 20 ns.
CCQ
Unit
(max) + 2.0
+125
+5.6
+5.6
Max
+85
100
Ambient Temperature
—
—
Test Condition
Unit
mA
°C
°C
SS
V
V
V
and input/
Datasheet
Notes
—
—
2
2
1
3
19