E82802AB8 S B48 Intel, E82802AB8 S B48 Datasheet - Page 23
![no-image](/images/manufacturer_photos/0/3/336/intel_sml.jpg)
E82802AB8 S B48
Manufacturer Part Number
E82802AB8 S B48
Description
Manufacturer
Intel
Datasheet
1.E82802AB8_S_B48.pdf
(53 pages)
Specifications of E82802AB8 S B48
Lead Free Status / RoHS Status
Not Compliant
4.7.
4.8.
4.9.
Datasheet
R
Block Erase Suspend Command
The Block Erase Suspend command allows block-erase interruption to read or program data in another
block of memory. Once the block erase process starts, writing the Block Erase Suspend command
requests that the WSM suspend the block erase sequence at a predetermined point in the algorithm. The
device outputs status register data when read after the Block Erase Suspend command is written. Polling
the status register can help determine when the block erase operation was suspended.
After a successful suspend, a Read Array command may be written to read data from a block other than
the suspended block. A Program command sequence may also be issued during erase suspend to program
data in blocks other that the block currently in the erase suspend mode.
The other valid commands while block erase is suspended include Read Status Register and Block Erase
Resume. After a Block Erase Resume command is written, the WSM will continue the block erase
process. V
erase is suspended. RST# or INIT# must also remain at V
operations initiated during block erase suspend have completed.
Program Suspend Comand
The Program Suspend command allows program interruption to read data in other memory locations.
Once the program process starts, writing the Program Suspend command requests that the WSM suspend
the program sequence at a predetermined point in the algorithm. The device continues to output status
register data when read after the Program Suspend command is written. Polling status register bits will
help determine when the program operation was suspended.
After a successful suspend, a Read Array command can be written to read data from locations other than
that which is suspended. The only other valid commands while program is suspended are Read Status
Register and Program Resume. After Program Resume command is written, the WSM will continue the
programming process. V
suspend mode. RST# or INIT# must also remain at V
Register Based Locking, General-Purpose Input, and
Random Number Generator Registers
A series of registers are available in the Intel FWH to provide software read- and write-locking and GPI
feedback. Also available are the set of control registers for controlling and gathering random numbers.
These registers are accessible through standard addressable memory space (see the following table).
It is recommended that the GPI pins be in the desired state before FWH4 is brought low for the
beginning of the next bus cycle, and remain in that state until the end of the read.
PP
must remain at V
PP
must remain at V
PPH1/2
(the same V
PPH1/2
PP
(the same V
level initially used for the block erase) while block
IH
.
IH
. Block erase cannot resume until program
PP
level used for program) while in program
Intel
®
82802AB/AC Firmware Hub
23