N82802AC8 Intel, N82802AC8 Datasheet - Page 40
![no-image](/images/manufacturer_photos/0/3/336/intel_sml.jpg)
N82802AC8
Manufacturer Part Number
N82802AC8
Description
Manufacturer
Intel
Datasheet
1.N82802AC8.pdf
(53 pages)
Specifications of N82802AC8
Lead Free Status / RoHS Status
Not Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
N82802AC8
Manufacturer:
INTEL
Quantity:
3
Company:
Part Number:
N82802AC8
Manufacturer:
INTEL
Quantity:
12 388
Part Number:
N82802AC8
Manufacturer:
INTEL
Quantity:
20 000
Intel
5.3.
5.4.
5.4.1.
5.4.1.1.
40
Table 15.
®
82802AB/AC Firmware Hub
Note:
Intel FWH Interface Cycles
Block Programming Times
Intel Firmware Hub Interface
Read Cycle Sequence
The firmware hub relies on the Intel Firmware Hub interface to communicate with the outside world.
This interface consists of four bi-directional signals and one “control” input. The timing and electrical
parameters of the FWH interface are similar to those of the LPC interface, to provide compatibility
between the interfaces, but differ in cases mentioned earlier in this section (clock pin capacitance), as
well as in certain timing parameters. The Intel ICH has been engineered to accommodate both interfaces,
which allows the Intel FWH interface signals to be communicated over the same set of pins as LPC. The
Intel FWH interface is designed to use an LPC-compatible start cycle, with a reserved cycle type code.
This ensures that all LPC devices present on the shared interface will ignore cycles destined for the
FWH, without becoming “confused” by the different protocol.
This section contains timing and protocol information for the Intel FWH interface. Note that the Intel
FWH interface is a licensed interface, so the appropriate license must be obtained from Intel for
components supporting the Intel FWH interface (e.g., ASICs, PLDs).
When the Intel FWH interface is active, information is transferred to and from the FWH by a series of
“fields,” where each field contains 4 bits of data. Many fields are one clock cycle in length but can be of
variable length, depending upon the nature of the field. Field sequences and contents are strictly defined
for read and write operations. The following tables list the field sequences for read and write cycles.
Addresses in this section refer to addresses as seen from the FWH’s “point of view,” so some calculation
will be required to translate these to the actual locations in the memory map (and vice versa).
The firmware hub supports single-byte or multibyte reads. The logic waveforms for these cycles are
shown in Table 16 and Figure 11
1.
2.
Byte program time
Block program time
Block erase time
Programming Times
Typical values measured at T A = +25°C and nominal voltages.
Excludes system-level overhead.
Parameter
Notes
2
2
2
Typ.
1.1
0.8
17
3.3 V V
(1)
Max.
PP
300
4.0
6.0
Typ.
7.0
0.5
0.3
12 V V
(1)
Max.
PP
125
1.5
4.0
Unit
sec
sec
µs
Datasheet
R