LFXP2-17E-6F484I LATTICE SEMICONDUCTOR, LFXP2-17E-6F484I Datasheet - Page 21

• Manufacturer Part Number: LFXP2-17E-6F484I
• Description: FPGA LatticeXP2 Family 17000 Cells Flash Technology 1.2V 484-Pin FBGA
• Manufacturer: LATTICE SEMICONDUCTOR

Specifications of LFXP2-17E-6F484I

• Package: 484FBGA
• Family Name: LatticeXP2
• Device Logic Units: 17000
• Typical Operating Supply Voltage: 1.2 V
• Maximum Number Of User I/os: 358
• Ram Bits: 282624
• Re-programmability Support: Yes

Lattice Semiconductor
For further information on the sysMEM EBR block, please see TN1137,
EBR Asynchronous Reset
EBR asynchronous reset or GSR (if used) can only be applied if all clock enables are low for a clock cycle before the
reset is applied and released a clock cycle after the low-to-high transition of the reset signal, as shown in Figure 2-18.
The GSR input to the EBR is always asynchronous.
Figure 2-18. EBR Asynchronous Reset (Including GSR) Timing Diagram
If all clock enables remain enabled, the EBR asynchronous reset or GSR may only be applied and released after
the EBR read and write clock inputs are in a steady state condition for a minimum of 1/f
release must adhere to the EBR synchronous reset setup time before the next active read or write clock edge.
If an EBR is pre-loaded during configuration, the GSR input must be disabled or the release of the GSR during
device Wake Up must occur before the release of the device I/Os becoming active.
These instructions apply to all EBR RAM and ROM implementations.
Note that there are no reset restrictions if the EBR synchronous reset is used and the EBR GSR input is disabled.
sysDSP™ Block
The LatticeXP2 family provides a sysDSP block making it ideally suited for low cost, high performance Digital Sig-
nal Processing (DSP) applications. Typical functions used in these applications include Bit Correlators, Fast Fourier
Transform (FFT) functions, Finite Impulse Response (FIR) Filter, Reed-Solomon Encoder/Decoder, Turbo Encoder/
Decoder and Convolutional Encoder/Decoder. These complex signal processing functions use similar building
blocks such as multiply-adders and multiply-accumulators.
sysDSP Block Approach Compare to General DSP
Conventional general-purpose DSP chips typically contain one to four (Multiply and Accumulate) MAC units with
fixed data-width multipliers; this leads to limited parallelism and limited throughput. Their throughput is increased by
higher clock speeds. The LatticeXP2 family, on the other hand, has many DSP blocks that support different data-
widths. This allows the designer to use highly parallel implementations of DSP functions. The designer can opti-
mize the DSP performance vs. area by choosing appropriate levels of parallelism. Figure 2-19 compares the fully
serial and the mixed parallel and serial implementations.
Reset
Clock
Clock
Enable
2-18
LatticeXP2 Memory Usage
LatticeXP2 Family Data Sheet
MAX
(EBR clock). The reset
Architecture
Guide.