1469054-1 TE Connectivity, 1469054-1 Datasheet - Page 6

• Manufacturer Part Number: 1469054-1
• Description: HM-ZD 2PR HDR SELECT LOAD
• Manufacturer: TE Connectivity

Specifications of 1469054-1

• Product Type: Connector
• Connector Type: Header
• Pcb Mounting Orientation: Vertical
• Shield Material: Phosphor bronze
• Module Length (mm [in]): 24.90 [0.980]
• Interface Type: HM-Zd
• Termination Method: Press Fit
• Termination End Plating: Tin-Lead over Nickel
• Card Slot Pitch (mm [in]): 20.3 [0.8]
• Columns Per Connector: 10
• Centerline (mm [in]): 2.50 [0.098]
• Selectively Loaded: Yes
• Number Of Positions: 32
• Contact Type: Pin
• Contact Termination Type: Through Hole
• Contact Configuration: ACTION PIN Post
• Feedthrough Post Length (mm [in]): 2.50 [0.098]
• Contact Mating Area Length (mm [in]): 6.35 [0.250]
• Contact Base Material: Phosphor Bronze
• Housing Material: Polyester GF
• Number Of Pairs Per Column: 2
• Number Of Pairs Per Connector: 20
• Sequenced Pins: Yes (See Drawing)
• Advancedtca Specified Product: No
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant

4.
4.1.
4.2.
4.3.
4.4.
Rev C
B.
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form , fit or function are m ade to the product or m anufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determ ined by developm ent/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product m eets the requirem ents of Figure 1. Failures
attributed to equipm ent, test setup, operator deficiencies, or applied non-Tyco com ponent(s) shall not
disqualify the product. If product failure occurs, corrective action shall be taken and specim ens
resubm itted for qualification. Testing to confirm corrective action is required before resubm ittal.
Quality Conform ance Inspection
The applicable quality inspection plan shall specify the sam pling acceptable quality level to be used.
Dim ensional and functional requirem ents shall be in accordance with the applicable product drawing
and this specification.
Four Pair HM-Zd Connectors (right angle receptacle, right angle header)
Specim en Selection
Specim ens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. All test groups shall each consist of a m inim um of 4
specim ens.
Test Sequence
Qualification inspection shall be verified by testing specim ens as specified in Figure 2.
NOTE
(a)
(b)
See paragraph 4.1.A.
Numbers indicate sequence in which tests are performed.
Low level contact resistance
Vibration
Mechanical shock
Tem perature rise vs current
Test or Exam ination
Figure 2B
Test Sequence (b)
1,3,5
Test Group (a)
1
2
4
2
1
108-2055
6 of 8