MAX1193ETI+ Maxim Integrated Products, MAX1193ETI+ Datasheet - Page 26

• Manufacturer Part Number: MAX1193ETI+
• Description: IC ADC 8BIT 45MSPS DUAL 28-TQFN
• Manufacturer: Maxim Integrated Products

Specifications of MAX1193ETI+

• Number Of Bits: 8
• Sampling Rate (per Second): 45M
• Data Interface: Parallel
• Number Of Converters: 2
• Voltage Supply Source: Single Supply
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 28-WFQFN Exposed Pad
• Conversion Rate: 45 MSPs
• Resolution: 8 bit
• Snr: 48.5 dB
• Voltage Reference: 1.024 V
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 2.7 V
• Maximum Power Dissipation: 1667 mW
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Input Voltage: 3 V
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
26 ____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600
© 2003 Maxim Integrated Products
(The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information
go to www.maxim-ic.com/packages.)
Ultra-Low-Power, 45Msps, Dual 8-Bit ADC
NOTES:
10. WARPAGE SHALL NOT EXCEED 0.10 mm.
2. ALL DIMENSIONS ARE IN MILLIMETERS. ANGLES ARE IN DEGREES.
3. N IS THE TOTAL NUMBER OF TERMINALS.
1. DIMENSIONING & TOLERANCING CONFORM TO ASME Y14.5M-1994.
4. THE TERMINAL #1 IDENTIFIER AND TERMINAL NUMBERING CONVENTION SHALL CONFORM TO JESD 95-1
5. DIMENSION b APPLIES TO METALLIZED TERMINAL AND IS MEASURED BETWEEN 0.25 mm AND 0.30 mm
6. ND AND NE REFER TO THE NUMBER OF TERMINALS ON EACH D AND E SIDE RESPECTIVELY.
7. DEPOPULATION IS POSSIBLE IN A SYMMETRICAL FASHION.
8. COPLANARITY APPLIES TO THE EXPOSED HEAT SINK SLUG AS WELL AS THE TERMINALS.
9. DRAWING CONFORMS TO JEDEC MO220.
SPP-012. DETAILS OF TERMINAL #1 IDENTIFIER ARE OPTIONAL, BUT MUST BE LOCATED WITHIN THE
ZONE INDICATED. THE TERMINAL #1 IDENTIFIER MAY BE EITHER A MOLD OR MARKED FEATURE.
FROM TERMINAL TIP.
COMMON DIMENSIONS
Printed USA
Package Information (continued)
is a registered trademark of Maxim Integrated Products.
TITLE:
APPROVAL
PROPRIETARY INFORMATION
PACKAGE OUTLINE
16, 20, 28, 32L, QFN THIN, 5x5x0.8 mm
EXPOSED PAD VARIATIONS
DOCUMENT CONTROL NO.
21-0140
REV.
C
2
2