CS5366-CQZR Cirrus Logic Inc, CS5366-CQZR Datasheet - Page 8

• Manufacturer Part Number: CS5366-CQZR
• Description: IC ADC 6CH 114DB 216KHZ 48-LQFP
• Manufacturer: Cirrus Logic Inc

Specifications of CS5366-CQZR

• Package / Case: 48-LQFP
• Number Of Bits: 24
• Sampling Rate (per Second): 216k
• Data Interface: Serial
• Number Of Converters: 1
• Power Dissipation (max): 830mW
• Voltage Supply Source: Analog and Digital
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Conversion Rate: 192 KSPs
• Resolution: 24 bit
• Number Of Adc Inputs: 6
• Operating Supply Voltage: 5 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Supply Voltage (max): 5.25 V
• Supply Voltage (min): 4.75 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1549 - BOARD EVAL FOR CS5366 192KHZ ADC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

8
Control Port Mode
SDA/CDOUT
CLKMODE
SCL/CCLK
AD1/CDIN
AD0/CS
MDIV
34
37
38
39
40
42
CLKMODE (Input) - This pin is ignored in Control Port Mode and the same functionality
is obtained from the corresponding bit in the Global Control Register. Note: Should be
connected to GND when using the part in Control Port Mode.
I²C Format, AD1 (Input) - Forms the device address input AD[1].
SPI Format, CDIN (Input) - Becomes the input data pin.
I²C Format, AD0 (Input) - Forms the device address input AD[0].
SPI Format, CS (Input) - Acts as the active low chip select input.
I²C Format, SCL (Input) - Serial clock for the serial control port. An external pull-up
resistor is required for I²C control port operation.
SPI Format, CCLK (Input) - Serial clock for the serial control port.
I²C Format SDA (Input/Output) - Acts as an input/output data pin. An external pull-up
resistor is required for I²C control port operation.
SPI Format CDOUT (Output) - Acts as an output only data pin.
MCLK Divider (Input) - This pin is ignored in Control Port Mode and the same function-
ality is obtained from the corresponding bit in the Global Control Register.
Note: Should be connected to GND when using the part in Control Port Mode.
CS5366
DS626F4