0640030100 Molex Inc, 0640030100 Datasheet - Page 11

• Manufacturer Part Number: 0640030100
• Manufacturer: Molex Inc

Specifications of 0640030100

• Lead Free Status / Rohs Status: RoHS Not Applicable

RHT-1992 Hand Crimp Tool
Doc No. 64003-0100 Release Date: 10-03-02
Revision: C
2. Partially close the tool to hold the terminal in place (See Figure 2).
3. Insert the properly stripped wire into the terminal barrel (See Figure 2 and 3). The wires end should stop
4. Remove the crimp and inspect for proper crimp location. Locator is adjustable up and down to keep terminals
5. When crimping butt splices, the locator must be removed. Insert the wire into the butt splice. Position the
6. When crimping parallel splices, the locator must be removed. Insert the 1
CONDUCTOR
SPLICE
BUTT
against the locator bar. Cycle the tool.
straight after crimping (See Figure 1). Molex offers a Crimp Inspection Handbook for closed barrel industrial
product. See our website or contact your sales engineer.
splice and the wire in proper coded nest with conductor crimp on the conductor barrel of the splice The splice
should be approximately centered inside the tooling nests (See Figure 4). Cycle the tool.
insert the 2
time. Make sure the wires are fully seated into the parallel splice. Position the splice and the wires in proper
PUNCH
CONDUCTOR
ANVIL
nd
Note: The tamper proof ratchet action will not release the tool until it has been fully
TERMINAL
wire into the opposite end of the parallel splice. This procedure will crimp both wires at the same
Revision Date: 09-02-04
Figure 4
Figure 2
WIRE
CENTER SPLICE
VISUALLY
TERMINAL
WIRE
UNCONTROLLED COPY
closed.
LOCATOR
2
ND
PARALLEL
WIRE
SPLICE
CONDUCTOR
Figure 3
ANVIL
st
wire into one end of splice then
Figure 5
CONDUCTOR
ANVIL
CONDUCTOR
PUNCH
WIRE
CENTER SPLICE
VISUALLY
CONDUCTOR
Page 11 of 16
PUNCH
1
ST
WIRE