0640030100 Molex Inc, 0640030100 Datasheet - Page 14

• Manufacturer Part Number: 0640030100
• Manufacturer: Molex Inc

Specifications of 0640030100

• Lead Free Status / Rohs Status: RoHS Not Applicable

RHT-1992 Hand Crimp Tool
Doc No. 64003-0100 Release Date: 10-03-02
Revision: C
How to Adjust Tool Preload (See Figure 7)
Over the life of the tool, it may be necessary to adjust tool handle preload force. Listed below are the steps required
to adjust the crimping force of the hand tool to obtain proper crimp conditions:
1. Remove the screw and plastic cover washer. Note the setting wheel position.
2. Lift the setting wheel off the axle. Turn the eccentric axle with a screwdriver.
3. Turning the eccentric axle counter-clockwise (CCW) will increase handle force.
4. Replace the setting wheel to the axle, aligning the nearest notch in the setting wheel to the dowel pin.
5. Replace the plastic cover washer and screw.
6. Check the crimp specifications after tool handle preload force is adjusted.
Tool Calibration
A Certificate of Calibration (See Last Page) was supplied with the tool. To recalibrate this Tool, a soft metal slug or
solder should be crimped in the conductor nest and the “X” Dimension measured in each conductor nest and compared
to this chart. The tool should be lubricated before recalibration to ensure consistent measurements. Handle preload is
factory set to 25-45 LBS. See How to Adjust Tool Preload (See Figure 7) to recalibrate.
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials. All vital
components are long-life tested. All tools are warranted free of manufacturing defects for a period of 30 days.
Should such a defect occur, we will repair or exchange the tool free of charge. This repair or exchange will not be
applicable to altered, misused or damaged tools. This tool is designed for hand use only. Any clamping, fixturing,
or use of handle extensions voids this warranty.
Hand held crimping tools are intended for low volume, prototyping, or repair requirements only.
Revision Date: 09-02-04
Nest Color Code
Caution: Repetitive use of this tool should be avoided.
Yellow
Blue
Red
X
18 - 22
14 - 16
10 - 12
AWG
Wire Range
“ F ” Crimp
0.35 - 0.80
1.30 - 2.00
3.30 - 5.00
UNCONTROLLED COPY
mm²
“X” Dimension Conductor Crimp
Mean
.073
.095
.127
CRIMPED UNINSULATED TERMINAL OR SLUG*
NOT POSSIBLE TO PIN GAUGE, MEASURE A
.068
.089
.121
Go
No Go
.078
.101
.133
SIMILAR SOFT METAL
*SOLDER, LEAD OR
Page 14 of 16