M68EML08JLJK Freescale Semiconductor, M68EML08JLJK Datasheet - Page 21

• Manufacturer Part Number: M68EML08JLJK
• Manufacturer: Freescale Semiconductor

Specifications of M68EML08JLJK

• Lead Free Status / Rohs Status: Not Compliant

2.3 Limitations
2.4 Remaining System Installation
2.4.1 MMDS0508 Installation
User’s Manual
MOTOROLA
Component
Table 2-1 Configuration Components (Continued)
Limitations listed here apply to using your EML08JLJK emulator, as opposed
to using the actual MCU in your target system:
Port pins PTD6 and PTD7 on EML08JLJK do not support 5k pull-up and
25mA high current open-drain outputs.
Once you have configured the oscillator select jumper header and set the MCU
emulation switch, you are ready to complete EML08JLJK installation.
To install the EML08JLJK in an MMDS0508 station module:
If your EML08JLJK is already installed in the station module:
•
•
•
•
•
•
•
Position
open
Remove the panel from the station module top
Fit together EM connectors P2 and P3 (on the bottom of the board) and
platform-board connectors P11 and P12, respectively.
Snap the corners of the EM onto the plastic standoffs.
Connect the target cable, if appropriate
Replace the panel.
Reconnect the target cable (if necessary)
Replace the panel
SW1
Preparation and Operation
JL3/JK3: Specifies emulation of an JL3/JK3 processor.
MCUID:0x45F. (Black as close on the dip switch)
1
ON -ON -ON -OFF-ON -OFF-OFF-OFF-OFF-OFF
2
3
4
M68EML08JLJK Emulation Module - Version 1.0
5
6
Effect
7
8
9
Preparation and Operation
10
Limitations
21