M68EML08JLJK Freescale Semiconductor, M68EML08JLJK Datasheet - Page 9

• Manufacturer Part Number: M68EML08JLJK
• Manufacturer: Freescale Semiconductor

Specifications of M68EML08JLJK

• Lead Free Status / Rohs Status: Not Compliant

1 - Set jumper J4 and MCUID switch SW1
2 - Install the emulation module into your development system
User’s Manual
MOTOROLA
User’s Manual — M68EML08JLJK Emulation Module
M68EML08JLJK Quick Start Guide
Make sure that power is disconnected from your M68EML08JLJK Emulator
Module and from your target system. Then follow these quick-start steps to
make your M68EML08JLJK ready for use as quickly as possible.
To specify the debugger-controlled oscillator from the platform board, place
the jumper between pins 3 and 4 (factory default).
To specify 32-MHz on board oscillator U18, place the jumper between pins 5
and 6.
To specify the on board oscillator socket (which can be replaced with an
oscillator of a different value), place the jumper between pins 1-2.
Set SW1 as MCUID: 0x461 as follows:
MCUID is the identify of an emulator. Debugger software will use emulator’s
MCUID to load specify memory file during software configuration.
To install the M68EML08JLJK in an MMDS0508 Motorola Modular
Development System (MMDS), take the following steps:
•
•
Remove the access panel of the MMDS station-module enclosure.
Insert the M68EML08JLJK through the access-panel opening.
Figure QS-1 MCUID: 0x461 for JL8 MCU Emulation
M68EML08JLJK Quick Start Guide
M68EML08JLJK Emulation Module - Version 1.0
open
SW1
9