BOXD865GLCL Intel, BOXD865GLCL Datasheet - Page 38

• Manufacturer Part Number: BOXD865GLCL
• Manufacturer: Intel

Specifications of BOXD865GLCL

• Lead Free Status / Rohs Status: Supplier Unconfirmed

Intel Desktop Board D865GBF/D865GLC Technical Product Specification
#
1.8.2 Universal 0.8 V / 1.5 V AGP 3.0 Connector
#
38
accessed by an ADD card. ADD cards can support up to two display devices with the following
configurations:
INTEGRATOR’S NOTES
The AGP connector supports the following:
AGP is a high-performance interface for graphics-intensive applications, such as 3D applications.
While based on the PCI Local Bus Specification, Rev. 2.2, AGP is independent of the PCI bus and
is intended for exclusive use with graphical display devices. AGP overcomes certain limitations of
the PCI bus related to handling large amounts of graphics data with the following features:
INTEGRATOR’S NOTES
For information about
The location of the AGP connector on the D865GBF board
The location of the AGP connector on the D865GLC board
Obtaining the Accelerated Graphics Port Interface Specification
TV-Out
Transition Minimized Differential Signaling (TMDS)
Low Voltage Differential Signaling (LVDS)
Single device operating in dual channel mode
Synchronous display is not supported when one of the display devices is a TV.
Synchronous display with two digital displays is not supported.
Digital Visual Interface (DVI) support is present only when an ADD card is installed.
4x, 8x AGP 3.0 add-in cards with 0.8 V I/O
1x, 4x AGP 2.0 add-in cards with 1.5 V I/O
AGP Digital Display (ADD) cards
Pipelined memory read and write operations that hide memory access latency
Demultiplexing of address and data on the bus for nearly 100 percent efficiency
AGP 2x operation is not supported.
Install memory in the DIMM sockets prior to installing the AGP video card to avoid
interference with the memory retention mechanism.
The AGP connector is keyed for Universal 0.8 V AGP 3.0 cards or 1.5 V AGP 2.0 cards only.
Do not attempt to install a legacy 3.3 V AGP card. The AGP connector is not mechanically
compatible with legacy 3.3 V AGP cards.
Refer to
Section 1.5, page 18
Figure 1, page 14
Figure 2, page 15