ST626XCKITEU STMicroelectronics, ST626XCKITEU Datasheet - Page 38

Manufacturer Part Number

ST626XCKITEU

Description

Manufacturer

STMicroelectronics

Datasheet

1.ST626XCKITEU.pdf (41 pages)

Lead Free Status / Rohs Status

Supplier Unconfirmed

Running Your Own program on the Starter Kit Board

4 Select USER mode using the jumpers marked W1 and W2 (marked 19 on the Starter Kit

5 Disconnect the cable from the parallel port (P1) connection, if it is connected

6 Disconnect the demonstration program selector by removing the jumper marked PA3 in the

7 If you are using your own hardware resources connected to J2 (marked 17 on the Starter

8 Power up the Starter Kit board.

38/41

board diagram on page 11), as shown in the diagram below:

Demonstration Selector circuit (marked 12 in the Starter Kit board diagram on page 11.)

Kit board diagram on page 11), disconnect any Starter Kit board resources that use the

same pins, following the instructions given in “Connecting External Resources to the Start-

er Kit Board” on page 25.

USER

PROG