GA355QR7GB103KW01L Murata Electronics, GA355QR7GB103KW01L Datasheet - Page 184

• Manufacturer Part Number: GA355QR7GB103KW01L
• Manufacturer: Murata Electronics

!Note
166
No.
10
* "Room condition" Temperature: 15 to 35°C, Relative humidity: 45 to 75%, Atmospheric pressure: 86 to 106kPa
1
2
3
4
5
6
7
8
9
GR7 Series Specifi cations and Test Methods
Operating
Temperature Range
Appearance
Dimensions
Dielectric Strength
Insulation Resistance
(I.R.)
Capacitance
Dissipation
Factor (D.F.)
Capacitance
Temperature
Characteristics
Adhesive Strength
of Termination
Vibration
Resistance
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifi cations. Therefore, please approve our product specifi cations or transact the approval sheet for product specifi cations before ordering.
Item
Appearance
Capacitance
D.F.
–55 to +125°C
No defects or abnormalities
Within the specified dimensions
No defects or abnormalities
CU0.01μF: More than 100MΩ
CF0.01μF: More than 10,000MΩ
Within the specified tolerance
0.025 max.
Cap. Change
No removal of the terminations or other defect should occur.
No defects or abnormalities
Within the specified tolerance
0.025 max.
Within ±10% (Apply DC350V bias)
Within
(Temp. Range : –55 to +125°C)
W22
Y33
% (No DC bias)
Specifications
Visual inspection
Using calipers and micrometers
No failure should be observed when DC500V is applied between
the terminations for 1 to 5 sec., provided the charge/discharge
current is less than 50mA.
The insulation resistance should be measured with DC250±50V
and within 60±5 sec. of charging.
The capacitance/D.F. should be measured at a frequency of
1±0.2kHz and a voltage of AC1±0.2V(r.m.s.).
The capacitance measurement should be made at each step
specified in the Table.
Solder the capacitor to the testing jig (glass epoxy board) shown
in Fig. 1.
Then apply 10N force in the direction of the arrow.
The soldering should be done using the reflow method and
should be conducted with care so that the soldering is uniform
and free of defects such as heat shock.
Solder the capacitor to the test jig (glass epoxy board).
The capacitor should be subjected to a simple harmonic motion
having a total amplitude of 1.5mm, the frequency being varied
uniformly between the approximate limits of 10 and 55Hz. The
frequency range, from 10 to 55Hz and return to 10Hz, should be
traversed in approximately 1 min. This motion should be applied
for a period of 2 hrs. in each of 3 mutually perpendicular
directions (total of 6 hrs.).
Perform a heat treatment at 150
let sit for 24±2 hrs. at room condition.*
Step
1
2
3
4
5
Glass Epoxy Board
Test Method
Max. Operating Temp.±2
Min. Operating Temp.±3
Fig. 1
–
Continued on the following page.
Temperature (°C)
Y10
W0
10N, 10±1s
Glass Epoxy Board
°C for 60±5 min. and then
25±2
25±2
25±2
Solder resist
Cu
C02E.pdf
Oct.1,2012