92250-588 FCI, 92250-588 Datasheet - Page 15

• Manufacturer Part Number: 92250-588
• Description: Telecom & Ethernet Connectors LOW PRO PCB 8 POS
• Manufacturer: FCI

Specifications of 92250-588

• Product: Telecom & Ethernet Connectors
• Usoc Codes: RJ45
• Number Of Ports: 1
• Shielding: Shielded
• Current Rating: 1 A
• Voltage Rating: 1000 V
• Housing Material: Nylon
• Color: Black
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

TITLE
Copyright FCI
Form E-3334
Rev E
6.5.
6.6.
Capacitance
Impedance
6.4.1. Transfer Impedance
6.4.2. Shielding System Effectiveness
The specification requirement shall be satisfied when evaluated in accordance with FCI Test
Specification BUS-03-114.The measurement shall be taken using unmated connectors between
two non-connected contacts where the worst possible case may exist. Probes shall be applied on
the PWB side.
Only filtered modjacks with inductive filters shall be tested.
The exact requirements shall be listed in appropriate customer specification or supply agreement.
Since a very large number of possible filters may be designed to satisfy a large number of
applications, the below listed table applies only to inductive filters furnished under part-numbers
95110-001, -002, and -004. Deviations of + or -20% from the nominal values listed in Table 6.6
are acceptable.
Single and Multi-Port Jack Assemblies
Where:
Defined as quotient of the longitudinal voltage in the outer system to the current in the
inner system.
A triaxial test set-up shall be used in accordance with IEC 61196.
All terminating resistors shall be 50 ohm
Maximum value is 1.3 ohm (to be verified)
The specification requirement shall be satisfied when evaluated in accordance with FCI
The following requirements are applicable to products with full shield. Every port should
have at least three grounding pegs. In lieu of grounding pegs, a copper tape can be used.
No shield effectiveness test required for products with partial shield.
Shielding effectiveness, dB
Frequency: 1 kHz
Amplitude: 1 Volt
Capacitance shall be less 10 pF
dB, Minimum
Test Specification BUS-03-107 and the following details:
I
@ MHz
U
Z
1
T
2
TYPE
Table 3 – Shielding Effectiveness
Z
PRODUCT SPECIFICATION
T
= U
2
voltage in the outer system
current in the inner system
transfer impedance
/I
1
25
40
PDM: Rev:J
SHIELDING EFFECTIVENESS, dB
125
30
250
28
STATUS:
NUMBER
PAGE
AUTHORIZED BY
STATUS
J.R. VOLSTORF
500
25
Released
15 of 26
UNRESTRICTED
GS-12-083
1000
22
Printed: Dec 09, 2008
REVISION
DATE
7-Jun-06
J
GS-01-001
.