92250-588 FCI, 92250-588 Datasheet - Page 20

• Manufacturer Part Number: 92250-588
• Description: Telecom & Ethernet Connectors LOW PRO PCB 8 POS
• Manufacturer: FCI

Specifications of 92250-588

• Product: Telecom & Ethernet Connectors
• Usoc Codes: RJ45
• Number Of Ports: 1
• Shielding: Shielded
• Current Rating: 1 A
• Voltage Rating: 1000 V
• Housing Material: Nylon
• Color: Black
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

TITLE
Copyright FCI
Form E-3334
Rev E
7.3.
7.4.
7.5.
Retention
Vibration and Mechanical Shock
Six position plug stress test
7.3.1. Effectiveness of connector coupling device.
7.3.2. Overall Assembly After Soldering.
7.3.3. Jack to Board.
7.4.1. Vibration
7.4.2. Mechanical Shock
Eight position, non-keyed jacks with stamped leadframe style terminals shall be capable of
withstanding mating with a six position FCC specified plug and not suffer overstress damage
to pins #1 and #8. After plugging ten times with a six-position plug, pins 1 and 8 shall maintain
100 grams minimum normal force when measured with a FCC minimum sized plug.
Single and Multi-Port Jack Assemblies
There shall be no evidence of mechanical damage to the jack, plug or latching
mechanism, nor separation of the plug from the jack when a static load of 50 N is applied
between the jack and plug in the direction of normal removal for 60 seconds while
clamped in place to support shearing between the board and jack.
There shall be no evidence of mechanical damage to the jack, plug or latching
mechanisms, nor of the plug from the jack or jack from the printed wiring board when a
static load of 22 Newtons is applied between the plug and the board in the direction of
normal plug removal.
This section does not apply to jacks without snap-in-pegs or press pegs.
Prior to soldering, the jack shall withstand a force applied between the jack and board in a
direction normal to the plane of the board as follows:
Snap-in pegs - 14.N
Diamond pegs (3.38mm in 3.20mm holes - 5.0N
Part shall be mounted onto PWB or fixtures. Vibration test shall be perform in accordance
to EIA 364-TP28B, test condition II (10 g sinusoidal excitation). Test duration shall be 2
hours on each of three mutually perpendicular axes. An event detector shall monitor
continuity during vibration testing for events of at least 50 ohm lasting 1.0 microsecond or
longer.
Mechanical shock test shall be performing in accordance to EIA-364-TP27, test condition
H (11 ms, 30g Half-sine excitation). Samples shall be subjected to three shocks in each
direction along each of the three mutually perpendicular axes of the samples, for a total of
18 shock impulses. An event detector shall monitor continuity during mechanical shock
testing for events of at least 50 ohm lasting 1.0 microsecond or longer.
TYPE
PRODUCT SPECIFICATION
PDM: Rev:J
STATUS:
NUMBER
PAGE
AUTHORIZED BY
STATUS
J.R. VOLSTORF
Released
20 of 26
UNRESTRICTED
GS-12-083
Printed: Dec 09, 2008
REVISION
DATE
7-Jun-06
J
GS-01-001
.