20-101-0673 Rabbit Semiconductor, 20-101-0673 Datasheet - Page 19

• Manufacturer Part Number: 20-101-0673
• Description: MODULE RABBITCORE RCM3610
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0673

• Module/board Type: MPU Core Module
• Product: Microcontroller Modules
• Core Processor: Rabbit 3000
• Clock Speed: 22.1 MHz
• Interface Type: Serial
• Flash: 256 KB
• Timers: 10 x 8 bit, 1 x 10 bit
• Operating Supply Voltage: 3 V to 3.6 V
• Board Size: 31 mm x 54 mm x 16 mm
• Core: RCM3610
• Processor Series: RCM3600
• For Use With/related Products: RCM3610
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1103

3.1 Introduction
To help familiarize you with the RCM3600 modules, Dynamic C includes several sample
programs. Loading, executing and studying these programs will give you a solid hands-on
overview of the RCM3600’s capabilities, as well as a quick start with Dynamic C as an
application development tool.
In order to run the sample programs discussed in this chapter and elsewhere in this manual,
1. Your RCM3600 must be plugged in to the Prototyping Board as described in Chapter 2,
2. Dynamic C must be installed and running on your PC.
3. The programming cable must connect the programming header (J2) on the RCM3600
4. Power must be applied to the RCM3600 through the Prototyping Board.
Refer to Chapter 2, “Getting Started,” if you need further information on these steps.
To run a sample program, open it with the
F9
Figure 8) and must be connected to a PC using the programming cable.
Complete information on Dynamic C is provided in the Dynamic C User’s Manual.
Getting Started
“Getting Started.”
to your PC.
or by selecting
To develop and debug programs for the RCM3600 (and for all
other Rabbit Semiconductor hardware), you must install and use
Dynamic C.
NOTE: The sample programs assume that you have at least an elementary grasp of the C
programming language. If you do not, see the introductory pages of the Dynamic C
User’s Manual for a suggested reading list.
Run
3. R
in the
UNNING
Run
menu. The RCM3600 must be in Program Mode (see
File
S
menu, then compile and run it by pressing
AMPLE
P
ROGRAMS
13