DC-ME-Y402-JT Digi International, DC-ME-Y402-JT Datasheet - Page 11
![MOD ME 9210 8MB SDRAM 4MB FLASH](/photos/6/75/67531/dc-me-y402-jt_sml.jpg)
DC-ME-Y402-JT
Manufacturer Part Number
DC-ME-Y402-JT
Description
MOD ME 9210 8MB SDRAM 4MB FLASH
Manufacturer
Digi International
Type
Network Controller & Processorr
Specifications of DC-ME-Y402-JT
Module/board Type
Device Server
Data Rate
11 Mbps
Memory Type
Flash, SDRAM
Interface Type
Ethernet
Operating Voltage
3.3 V
Operating Current
250 mA
Maximum Power Dissipation
825 mW
Operating Temperature Range
- 40 C to + 85 C
Board Size
36.7 mm x 19.1 mm x 21.7 mm
Data Bus Width
32 bit
Modulation
CCK, DBPSK, DQPSK
Product
Modules
Security
64/128 bit WEP, TKIP, WPA, WPA2
For Use With/related Products
Networking
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
602-1135
11
Connectors: Ethernet Interface
Note:
Note:
Note:
The Ethernet connector is an 8-wire RJ-45 jack that meets the ISO 8877 requirements for
10/100BASE-T. See the following figure and table for pin orientation and pin assignments.
Note:
Ethernet Interface Pin Orientation
17, 18
Pin
19
20
The development board provides connectors for an optional PoE application kit.
Any pins not used can be left floating.
See "Module Pinout" on page 33 for detailed IO configuration information.
Pin orientation and assignments are the same for modules with or without a JTAG
connector.
/INIT
Power and Device Interface Connector Pin Assignments
ME
Signal
/INIT
Wi-ME
Reserved. Do not connect.
Not accessible with Digi Plug-and-Play
Firmware. If using a development kit, see
"Module Pinout" on page 33 for detailed IO
configuration information.
Software Reset
Description