DC-ME-Y402-JT Digi International, DC-ME-Y402-JT Datasheet - Page 59
![MOD ME 9210 8MB SDRAM 4MB FLASH](/photos/6/75/67531/dc-me-y402-jt_sml.jpg)
DC-ME-Y402-JT
Manufacturer Part Number
DC-ME-Y402-JT
Description
MOD ME 9210 8MB SDRAM 4MB FLASH
Manufacturer
Digi International
Type
Network Controller & Processorr
Specifications of DC-ME-Y402-JT
Module/board Type
Device Server
Data Rate
11 Mbps
Memory Type
Flash, SDRAM
Interface Type
Ethernet
Operating Voltage
3.3 V
Operating Current
250 mA
Maximum Power Dissipation
825 mW
Operating Temperature Range
- 40 C to + 85 C
Board Size
36.7 mm x 19.1 mm x 21.7 mm
Data Bus Width
32 bit
Modulation
CCK, DBPSK, DQPSK
Product
Modules
Security
64/128 bit WEP, TKIP, WPA, WPA2
For Use With/related Products
Networking
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
602-1135
Antenna configurations
59
This device has been designed to operate with the antennas listed below, and having a
maximum gain of [10] dBi. Antennas not included in this list or having a gain greater than
[10] dBi are strictly prohibited for use with this device. The required antenna impedance is
[50] ohms
The following antenna configurations that were tested with the Connect Wi-ME 802.11 b
module.
Digi 29000095, Bobbintron SA-006-1, +2 dBi dipole antenna (NP-SMA)
PCTEL, MLPV2400NGP, 2.4 GHz, 3dBi gain, no ground place, low profile antenna
MAXRAD, MFB24010, 2.4 GHz, 10 dBi Fiberglass OMNI antenna
To reduce potential radio interference to other users, the antenna type and its gain should be
so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
permitted for successful communication.