DC-ME-Y402-JT Digi International, DC-ME-Y402-JT Datasheet - Page 38
![MOD ME 9210 8MB SDRAM 4MB FLASH](/photos/6/75/67531/dc-me-y402-jt_sml.jpg)
DC-ME-Y402-JT
Manufacturer Part Number
DC-ME-Y402-JT
Description
MOD ME 9210 8MB SDRAM 4MB FLASH
Manufacturer
Digi International
Type
Network Controller & Processorr
Specifications of DC-ME-Y402-JT
Module/board Type
Device Server
Data Rate
11 Mbps
Memory Type
Flash, SDRAM
Interface Type
Ethernet
Operating Voltage
3.3 V
Operating Current
250 mA
Maximum Power Dissipation
825 mW
Operating Temperature Range
- 40 C to + 85 C
Board Size
36.7 mm x 19.1 mm x 21.7 mm
Data Bus Width
32 bit
Modulation
CCK, DBPSK, DQPSK
Product
Modules
Security
64/128 bit WEP, TKIP, WPA, WPA2
For Use With/related Products
Networking
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
602-1135
Network Interface
Serial Interface
Standard: IEEE 802.3
Physical Layer: 10/100Base-T
Data Rate: 10/100Mbps (auto-sensing)
Mode: Half-duplex and full-duplex support
Connector: RJ-45
(auto-sensing)
Digi Connect ME/ME9210
One TTL serial interface (CMOS 3.3v) with full modem control signals (DTR, DSR, DCD,
RTS, CTS). The Connect ME 9210 also supports SPI and FIM-based application specific
interfaces.
Module Specifications
A
P
P
Caution: The Digi Connect ME and Digi Connect Wi-ME embedded
modules were designed for use in no clean flux wave soldering processes.
The product is not designed to support draining after a water-wash
process, which can lead to water residue inside the enclosure resulting
from direct entry or condensation after the wash process.
E
N
D
I
X
A
Standard: IEEE 802.11b
Frequency: 2.4 GHz
Data Rate: Up to 11 Mbps with automatic fallback
Modulation: CCK (11/5 Mbps), DQPSK (2 Mbps),
DBPSK (1 Mbps)
Transmit Power: 16 dBm typical
Receive sensitivity:
Antenna Connector: 1 x RP-SMA
–
–
–
–
1Mbps: -92 dBm
2Mbps: -89 dBm
5.5Mbps: -87 dBm
11Mbps: -82 dBm
Digi Connect Wi-ME
3 8