20-101-0497 Rabbit Semiconductor, 20-101-0497 Datasheet - Page 9

• Manufacturer Part Number: 20-101-0497
• Description: MODULE OP6810 W/O ETH/MEM EXPANS
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0497

• Module/board Type: Single Board Computer Module
• Product: Prototyping Accessories
• Processor Type: Rabbit 2000
• Sram: 128 KB
• Flash: 256 KB
• Timers: 8 bit, 10 bit
• Number Of I/os: 24
• Operating Voltage: 9 V to 36 V
• Power Consumption: 1.5 W
• Board Size: 111 mm x 91 mm x 33 mm
• For Use With/related Products: OP6810
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 20-101-497; 20-101-497

1.4.1 Design Guidelines
Note the following requirements for incorporating the OP6800 operator interfaces into
your application to comply with CE requirements.
General
• The power supply provided with the Tool Kit is for development purposes only. It is the
• When connecting the OP6800 to outdoor cables, the customer is responsible for provid-
• Rabbit recommends placing digital I/O or analog cables that are 3 m or longer in a
• While the OP6800 meets the EN61000-4-2 (ESD) requirements in that it can withstand
Safety
• For personal safety, all inputs and outputs to and from the OP6800 must not be con-
• The lithium backup battery circuit on the OP6800 has been designed to protect the bat-
1.4.2 Interfacing the OP6800 to Other Devices
Since the OP6800 operator control panels are designed to be connected to other devices,
good EMC practices should be followed to ensure compliance. CE compliance is ulti-
mately the responsibility of the integrator. Additional information, tips, and technical
assistance are available from your authorized Rabbit distributor, and are also available on
our Web site at www.rabbit.com.
User’s Manual
customer’s responsibility to provide a CE-compliant power supply for the end-product
application.
ing CE-approved surge/lightning protection.
metal conduit to assist in maintaining CE compliance and to conform to good cable
design practices. Rabbit also recommends using properly shielded I/O cables in noisy
electromagnetic environments.
contact discharges of ± 4 kV and air discharges of ± 8 kV, it is the responsibility of the
end-user to use proper ESD precautions to prevent ESD damage when installing or ser-
vicing the OP6800.
nected to voltages exceeding SELV levels (42.4 V AC peak, or 60 V DC). Damage to
the Rabbit 2000 microprocessor may result if voltages outside the design range of 0 V
to 40 V DC are applied directly to any of its digital inputs.
tery from hazardous conditions such as reverse charging and excessive current flows.
Do not disable the safety features of the design.
5