ATA6625-TAPY 19 Atmel, ATA6625-TAPY 19 Datasheet - Page 10

TXRX LIN BUS 5V W/VREG 8SOIC

ATA6625-TAPY 19

Manufacturer Part Number
ATA6625-TAPY 19
Description
TXRX LIN BUS 5V W/VREG 8SOIC
Manufacturer
Atmel
Type
Transceiverr
Datasheet

Specifications of ATA6625-TAPY 19

Number Of Drivers/receivers
1/1
Protocol
LIN
Voltage - Supply
5 V ~ 27 V
Mounting Type
Surface Mount
Package / Case
SO-8
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
5. Fail-safe Features
10
Atmel ATA6623/ATA6625
• During a short-circuit at LIN to V
• During a short-circuit from LIN to GND the IC can be switched into Sleep or Silent Mode. If
• The reverse current is very low < 2µA at pin LIN during loss of V
• During a short circuit at VCC, the output limits the output current to I
• Pin EN provides a pull-down resistor to force the transceiver into Recessive Mode if EN is
• Pin RXD is set floating if V
• Pin TXD provides a pull-up resistor to force the transceiver into Recessive Mode if TXD is
• If TXD is short-circuited to GND, it is possible to switch to Sleep Mode via ENABLE after
the power dissipation, the chip temperature exceeds T
off. The chip cools down and after a hysteresis of T
stays on high because LIN is high. During LIN overtemperature switch-off, the V
regulator is working independently.
the short-circuit disappears, the IC starts with a remote wake-up.
behavior for bus systems where some slave nodes are supplied from battery or ignition.
undervoltage, NRES switches to low and sends a reset to the microcontroller. The IC
switches into Fail-safe Mode. If the chip temperature exceeds the value T
output switches off. The chip cools down and after a hysteresis of T
on again. Because of Fail-safe Mode, the V
switched off from the microcontroller. The microcontroller can then start with normal
operation.
disconnected.
disconnected.
t
dom
> 20ms.
Batt
is disconnected.
Battery
, the output limits the output current to I
CC
voltage will switch on again although EN is
hys
, switches the output on again. RXD
LINoff
and the LIN output is switched
Batt
. This is optimal
hys
VCClim
, switches the output
VCCoff
. Because of
BUS_lim
4957I–AUTO–03/11
, the V
CC
. Due to
CC

Related parts for ATA6625-TAPY 19