PSB21150HV14XP Lantiq, PSB21150HV14XP Datasheet - Page 196

• Manufacturer Part Number: PSB21150HV14XP
• Manufacturer: Lantiq

Specifications of PSB21150HV14XP

• Number Of Line Interfaces: 1
• Control Interface: HDLC
• Lead Free Status / Rohs Status: Compliant

IPAC-X
PSB/PSF 21150
Detailed Register Description
4.2.12
ISTATR - Interrupt Status Register Transceiver
Value after reset: 00
H
7
0
ISTATR
x
x
x
x
LD
RIC
SQC
SQW
RD (38)
For all interrupts in the ISTATR register the following logical states are defined:
0: Interrupt is not acitvated
1: Interrupt is acitvated
x ... Reserved
Bits set to “1” in this bit position must be ignored.
LD ... Level Detection
Any receive signal has been detected on the line. This bit is set to “1” (i.e. an interrupt is
generated if not masked) as long as any receiver signal is detected on the line.
RIC ... Receiver INFO Change
RIC is activated if one of the TR_STA bits RINF or ICV has changed. This bit is reset by
reading the TR_STA register.
SQC ... S/Q-Channel Change
A change in the received S-channel (TE) or Q-channel (NT) has been detected. The new
code can be read from the SQRxx bits of registers SQRR1-3 within the next multiframe
(5 ms). This bit is reset by a read access to the corresponding SQRRx register.
SQW ... S/Q-Channel Writable
The S/Q channel data for the next multiframe is writable.
The register for the Q (S) bits to be transmitted (received) has to be written (read) within
the next multiframe (5 ms). This bit is reset by writing register SQXRx.
Data Sheet
196
2003-01-30