85-10 3M Interconnect Solutions, 85-10 Datasheet - Page 2

• Manufacturer Part Number: 85-10
• Manufacturer: 3M Interconnect Solutions

Specifications of 85-10

• Lead Free Status / Rohs Status: Compliant

3.2
3.3
3.4
3.5
3.6
3.7
Note:
3.0 Cable Connection for Horizontal Run
3.1
Make Connection. Make connection according to connector
manufacturer's instructions. Crimped connector length should
not be more than dimension "A".
Table for dimension "A"
Train Cables. Place cables in a horizontal position. Spread
legs of cable so there will be 3/8" space between cables to
allow for sealing around each cable with mastic sealing strips.
Prepare Mold Body. Remove liners from sealing mastic on
mold body.
Position Mold Body Around Splice. Center mold body
along connector. Wrap mold body around connection.
Seal Film. Seal film together between spacer pad and mastic.
Seal Mold. Starting at bottom of mold, seal and compress
sealing mastic around and between each cable to form a resin
tight seal.
Prepare Cable. Scrape each cable exterior clean for a distance
of 5" (8" for 85-16) from connector. If cable is sheathed,
pencil insulation 3/4".
Compress the sealing mastic around and between each
cable with thumbs as shown.
85-10
1 1/2"
85-12
1 1/2"
4 1/2"
85-14
85-16
6"
2
minimum
3/8"
A
78-8124-4519-1-B