85-10 3M Interconnect Solutions, 85-10 Datasheet - Page 4

• Manufacturer Part Number: 85-10
• Manufacturer: 3M Interconnect Solutions

Specifications of 85-10

• Lead Free Status / Rohs Status: Compliant

Important Notice
All statements, technical information, and recommendations related to 3M’s products are based on information believed to be reliable, but the
accuracy or completeness is not guaranteed. Before using this product, you must evaluate it and determine if it is suitable for your intended
application. You assume all risks and liability associated with such use. Any statements related to the product which are not contained in
3M’s current publications, or any contrary statements contained on your purchase order shall have no force or effect unless expressly agreed
upon, in writing, by an authorized officer of 3M.
Warranty; Limited Remedy; Limited Liability.
This product will be free from defects in material and manufacture for a period of one (1) year from the time of purchase. 3M MAKES NO
OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE. If this product is defective within the warranty period stated above, your exclusive remedy shall be, at 3M’s
option, to replace or repair the 3M product or refund the purchase price of the 3M product. Except where prohibited by law, 3M will not
be liable for any indirect, special, incidental or consequential loss or damage arising from this 3M product, regardless of the legal
theory asserted.
4.5
4.6
4.7
NOTE: DO NOT MOVE CABLES OR SPLICE UNTIL
5.0 Other Installation Hints
5.1
5.2
3M and Scotchcast are trademarks of 3M Company.
Electrical Markets Division
6801 River Place Blvd.
Austin, TX 78726-9000
800-626-8381
Fax [phone]
www.3M.com/electrical
Remove liner from adhesive film strip supplied with kit.
Seal the open side of mold. Bring the mold's edges
together, fold over and compress the adhesive film strip.
Be sure the seal is complete.
Mix the resin per instructions on resin package. Pour
into mold.
The 3M
show only a typical tap splice. Some general rules for insulating multiple splice configurations follow.
For Multiple Tap Connections. Follow the same procedures in these instructions. The number of taps
the multi-mode kit can handle will depend on the connector and the size of the cables being spliced. The
following guidelines should be used:
a) In making horizontal splices, cables should be brought out of the splice from the sides (through the
b) Resin coverage along cable sheath or jacket must be a minimum of 1" for a proper moisture seal.
c) The sealing mastic must surround each cable to ensure a resin tight seal.
d) In making vertical splices, cables can be brought out the top of the mold.
RESIN HAS COMPLETELY HARDENED.
sealing mastic) and not out of the top of the splice. This will ensure the proper length of cable to be
sealed in resin.
™
Scotchcast
™
Multi-mold Kits can insulate many more splice configurations. These instructions
Recycled paper
40% Pre-consumer waste paper
10% Post-consumer waste paper
Litho in USA
© 3M 2005 78-8124-4519-1-B