ZMOTIONS200ZCOG Zilog, ZMOTIONS200ZCOG Datasheet - Page 22

• Manufacturer Part Number: ZMOTIONS200ZCOG
• Description: KIT DEV ZMOTION MODULE
• Manufacturer: Zilog
• Series: ZMOTION™r

Specifications of ZMOTIONS200ZCOG

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Sensing Range: -
• Interface: USB/Serial
• Sensitivity: -
• Voltage - Supply: -
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ZMOT1AHH
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 269-4823

UM023301-0411
Note:
set to
Deselect the
changes to this and the other subfolders when prompted.
In this example, we reference the
however, the steps that follow will apply to any additional project.
At this point you should have loaded ZDS II and the Smart Cable USB driver
on to your computer. If you haven’t yet done so, revisit the beginning of this
Installing ZDS II and the USB Smart Cable section before proceeding.
1. Open ZDS II and select
2. Open the
3. Click the
project folder labeled
first receive your kit, this project is already loaded into the ZMOTION
MCU. Right-click within the open grey area below the menu icons and
select
and therefore make it easier to switch between files.
not indicate any errors. If you receive errors, try reloading the projects
from the original Application CD and ensure that the folders are not
set to
location of the
Read Only
Read Only
Workbook Mode
Read Only
Rebuild All
ZMOTION_Intrusion_Demo.zdsproj
by right-clicking the folder and selecting properties.
ZMOTION
Rebuild All
. See Figure 5 for an example; Figure 6 indicates the
ZMOTION Intrusion Detection Development Board
attribute and click
icon to build the project. The build output should
ZMOTION_Intrusion_Demo
File
to turn on the tabs at the bottom of the editor
™
icon in the ZDS II menu bar.
Intrusion Detection Development Kit
→
ZMOTION_Intrusion_Demo
Open Project
OK
. Make sure you apply
, then navigate to the
project. When you
.
User Manual
project;
18