SPIS01 Xeltek, SPIS01 Datasheet - Page 6

• Manufacturer Part Number: SPIS01
• Description: SUPERPRO IS01 PROGRAMMER
• Manufacturer: Xeltek
• Series: SuperPro®r
• Type: ISP (In-System Reprogramming)r

Specifications of SPIS01

• Contents: Programmer, AC Adapter, Cable, CD, SD Card
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: E/EPROM, FLASH, PLD, Micros and more listed on Device Sheet
• Other names: 415-1053

+
Definition of several common interfaces
corresponding to ISP port (this definition only contains communication protocol pins, for
the specific wiring method, please refer to the hint on the software of host computer), the
pin correspondence table is as follows:
the port are provided for this purpose. TPOUT supplies high level, and TPIN is level
detection input line. Short-circuit them on the target board, once ISP signal is applied to
the test point, TPIN immediately detects high level, and AUTO command sequence can
be started.
2. Reserved1-2 is only used when the multi-object system is programming. On some
target board there are several identical I2C chips that need to be burned, and the chip that
needs to be burned currently can be selected through address line, then, Reserved1-2 is
connected to A0 and A2, respectively.
Port B is a 5X2 port. CAN and RS-232 come out from this port. The pins are defined as
below:
In order to facilitate use by customer, we have defined several common interfaces
6