CB-OWS451X-04-0 ConnectBlue, CB-OWS451X-04-0 Datasheet - Page 7

• Manufacturer Part Number: CB-OWS451X-04-0
• Description: RF SERIAL PORT ADAPTER U.FL
• Manufacturer: ConnectBlue
• Series: CB-OWSr

Specifications of CB-OWS451X-04-0

• Frequency: 2.4GHz, 5GHz
• Data Rate - Maximum: 115 kbps
• Modulation Or Protocol: 802.11 a/b/g/n
• Applications: General Purpose
• Power - Output: 20dBm (100mW)
• Sensitivity: -89dBm
• Voltage - Supply: 3.3 V ~ 5.5 V
• Current - Receiving: -
• Current - Transmitting: -
• Data Interface: Solder Pad
• Memory Size: -
• Antenna Connector: U.FL x 2
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Modular
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 809-1041

connectBlue
Copyright © 2010 connectBlue AB
This section describes the signals available on the module interface connectors. There are three ways of connecting:
Optional:
J8 is the JST connector located on the primary side of the module. A1 is the internal antenna.
J4 and J5 are U.FL connectors for external antennas. J4 is the primary antenna connector and J5 the auxiliary antenna connector.
J2 and J3 is the connectBlue board-to-board connector. The pin layout of the connector is compatible with all OEM Serial Port Adapters
from connectBlue.
The J6 is the solder land connector.
3 Electrical interface and connectors
3.1 Pin numbering
3.1.1 Primary side connectors
3.1.2 Secondary side connectors
Via the PCB solder lands on the edge of the PCB, J6 (see figure below: Secondary side connectors). For more information see
Section J6 Solder Lands Description.
Via the 2 x 20-pin 1mm pitch board-to-board (one piece part) connectors J2 and J3. The J2 and J3 connectors exist on the
module only as compression pads (see figure below: Secondary side connectors). These pads mates with the carrier board
one-piece part connector. For more information see Section J2 Connector Description and J3 Connector Description.
Via the JST connector, J8 (see figure below: Primary side connectors). The connector is a 6 poles pin header. The pitch is 1mm
and the connector is from JST with part number SM06B-SRSS-TB. For more information see section J8 Connector Description.
Page 7 of 26