C8051T605-GSR Silicon Laboratories Inc, C8051T605-GSR Datasheet - Page 60

• Manufacturer Part Number: C8051T605-GSR
• Description: MCU 8-Bit C8051T60x 8051 CISC 2KB EPROM 1.8V/3V 14-Pin SOIC T/R
• Manufacturer: Silicon Laboratories Inc

Specifications of C8051T605-GSR

• Package: 14SOIC
• Device Core: 8051
• Family Name: C8051T60x
• Maximum Speed: 25 MHz
• Ram Size: 256 Byte
• Program Memory Size: 2 KB
• Operating Supply Voltage: 1.8|3 V
• Data Bus Width: 8 Bit
• Program Memory Type: EPROM
• Number Of Programmable I/os: 8
• Interface Type: I2C/SMBus/UART
• Operating Temperature: -40 to 85 °C
• Number Of Timers: 3

C8051T600/1/2/3/4/5/6
externally driven from –0.25 V to (V
trical specifications are given in Section “8. Electrical Characteristics” on page 30.
The Comparator response time may be configured in software via the CPT0MD register (see SFR Defini-
tion 13.2). Selecting a longer response time reduces the Comparator supply current.
The Comparator hysteresis is software-programmable via its Comparator Control register CPT0CN. The
user can program both the amount of hysteresis voltage (referred to as the input voltage) and the positive
and negative-going symmetry of this hysteresis around the threshold voltage.
The Comparator hysteresis is programmed using Bits3–0 in the Comparator Control Register CPT0CN
(shown in SFR Definition 13.1). The amount of negative hysteresis voltage is determined by the settings of
the CP0HYN bits. As shown in Figure 13.2, settings of 20, 10 or 5 mV of negative hysteresis can be pro-
grammed, or negative hysteresis can be disabled. In a similar way, the amount of positive hysteresis is
determined by the setting the CP0HYP bits.
Comparator interrupts can be generated on both rising-edge and falling-edge output transitions. (For Inter-
rupt enable and priority control, see Section “17.1. MCU Interrupt Sources and Vectors” on page 81). The
CP0FIF flag is set to logic 1 upon a Comparator falling-edge occurrence, and the CP0RIF flag is set to
logic 1 upon the Comparator rising-edge occurrence. Once set, these bits remain set until cleared by soft-
ware.
The output state of the Comparator can be obtained at any time by reading the CP0OUT bit. The Compar-
ator is enabled by setting the CP0EN bit to logic 1, and is disabled by clearing this bit to logic 0.
60
(Programmed with CP0HYP Bits)
Positive Hysteresis Voltage
INPUTS
OUTPUT
VIN+
VIN-
CIRCUIT CONFIGURATION
Positive Hysteresis
CP0-
CP0+
VIN+
VIN-
Disabled
V
OL
Figure 13.2. Comparator Hysteresis Plot
V
OH
+
_
CP0
DD
) + 0.25 V without damage or upset. The complete Comparator elec-
Positive Hysteresis
Maximum
OUT
Rev. 1.2
Negative Hysteresis
Disabled
Negative Hysteresis
(Programmed by CP0HYN Bits)
Maximum
Negative Hysteresis Voltage