SI3018-F-FT Silicon Laboratories Inc, SI3018-F-FT Datasheet - Page 60
![no-image](/images/manufacturer_photos/0/6/609/silicon_laboratories_inc_sml.jpg)
SI3018-F-FT
Manufacturer Part Number
SI3018-F-FT
Description
IC VOICE DAA GCI/PCM/SPI 16TSSOP
Manufacturer
Silicon Laboratories Inc
Datasheet
1.SI3018-F-FT.pdf
(112 pages)
Specifications of SI3018-F-FT
Function
Data Access Arrangement (DAA)
Interface
Serial
Number Of Circuits
1
Voltage - Supply
3 V ~ 3.6 V
Current - Supply
8.5mA
Operating Temperature
0°C ~ 70°C
Mounting Type
Surface Mount
Package / Case
16-TSSOP
Includes
Line Voltage Monitor, Loop Current Monitor, Overload Detection, Parallel Handset Detection, Polarity Reversal Detection, TIP and
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Power (watts)
-
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
SI3018-F-FT
Manufacturer:
SiliconL
Quantity:
960
Si3050
Register 1. Control 1
Reset settings = 0000_0000
60
Bit
5:4
7
6
3
2
1
0
Name
Type
Bit
PWMM[1:0] Pulse Width Modulation Mode.
Reserved Read returns zero.
Reserved Read returns zero.
Reserved Read returns zero.
PWME
Name
IDL
SR
R/W
SR
D7
Software Reset.
0 = Enables the DAA for normal operation.
1 = Sets all registers to their reset value.
Note: Bit automatically clears after being set.
Used to select the type of signal output on the call progress AOUT pin.
00 = PWM output is clocked at 16.384 MHz as a delta-sigma data stream. A local density of
1s and 0s tracks the combined transmit and receive signals. Use this setting with the optional
call progress circuit shown in Figure 18 on page 19.
01 = Balanced conventional PWM output signal has high and low portions of the modulated
pulse that are centered on the 16 kHz sample clock.
10 = Conventional PWM output signal returns to logic 0 at regular 32 kHz intervals and rises
at a time in the 32 kHz period proportional to its instantaneous amplitude.
11 = Reserved.
Pulse Width Modulation Enable.
0 = Pulse width modulation mode disabled (AOUT).
1 = Enable pulse width modulation mode for the call progress analog output (AOUT). This
mode sums the transmit and receive audio paths and presents this as a CMOS digital-level
output of PWM data. The circuit in Figure 18 on page 19 should be used.
Isolation Digital Loopback.
0 = Digital loopback across the isolation barrier is disabled.
1 = Enables digital loopback mode across the isolation barrier. The line-side device must be
enabled and off-hook prior to setting this mode. The data path includes the TX and RX filters.
D6
D5
PWMM[1:0]
R/W
Rev. 1.2
D4
Function
PWME
R/W
D3
D2
R/W
IDL
D1
D0