AT89LP214 Atmel Corporation, AT89LP214 Datasheet - Page 73

• Manufacturer Part Number: AT89LP214
• Manufacturer: Atmel Corporation

Specifications of AT89LP214

• Flash (kbytes): 2 Kbytes
• Max. Operating Frequency: 20 MHz
• Cpu: 8051-1C
• Max I/o Pins: 12
• Spi: 1
• Uart: 1
• Sram (kbytes): 0.125
• Operating Voltage (vcc): 2.4 to 5.0
• Timers: 2
• Isp: SPI/OCD
• Watchdog: Yes

23.8
23.8.1
23.8.2
3538E–MICRO–11/10
Programming Interface Timing
Power-up Sequence
Power-down Sequence
This section details general system timing sequences and constraints for entering or exiting In-
System Programming as well as parameters related to the Serial Peripheral Interface during
ISP. The general timing parameters for the following waveform figures are listed in Section
23.8.6 “Timing Parameters” on page
Execute this sequence to enter programming mode immediately after power-up. In the RST pin
is disabled or if the ISP Fuse is disabled, this is the only method to enter programming (see
tion 10.3 “External Reset” on page
Figure 23-5. Serial Programming Power-up Sequence
Execute this sequence to power-down the device after programming.
Figure 23-6. Serial Programming Power-down Sequence
1. Apply power between VCC and GND pins. RST should remain low.
2. Wait at least t
3. Wait at least t
4. Start programming session.
1. Drive SCK low.
2. Wait at least t
3. Tristate MOSI.
4. Wait at least t
5. Wait no more than t
depend on the current settings of the device.
MISO
MOSI
MISO
MOSI
SCK
RST
V
RST
SCK
V
SS
CC
SS
CC
t
SSD
PWRUP
SUT
SSD
SSZ
and then tristate SS and SCK.
for the internal Power-on Reset to complete. The value of t
and bring SS high.
. and drive SS high.
PWRDN
t
PWRUP
and power off VCC.
16).
t
SSZ
76.
HIGH Z
HIGH Z
HIGH Z
HIGH Z
t
POR
+ t
SUT
t
PWRDN
t
ZSS
AT89LP213/214
SUT
will
Sec-
73