SAM7X512 Atmel Corporation, SAM7X512 Datasheet - Page 27

• Manufacturer Part Number: SAM7X512
• Manufacturer: Atmel Corporation

Specifications of SAM7X512

• Flash (kbytes): 512 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 55 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 62
• Ext Interrupts: 62
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Twi (i2c): 1
• Uart: 3
• Can: 1
• Ssc: 1
• Ethernet: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 128
• Self Program Memory: NO
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

9.3
9.4
6120GS–ATARM–07-Apr-11
Power Management Controller
Advanced Interrupt Controller
The Power Management Controller uses the Clock Generator outputs to provide:
The Master Clock (MCK) is programmable from a few hundred Hz to the maximum operating fre-
quency of the device.
The Processor Clock (PCK) switches off when entering processor idle mode, thus allowing
reduced power consumption while waiting for an interrupt.
Figure 9-3.
• the Processor Clock PCK
• the Master Clock MCK
• the USB Clock UDPCK
• all the peripheral clocks, independently controllable
• four programmable clock outputs
• Controls the interrupt lines (nIRQ and nFIQ) of an ARM Processor
• Individually maskable and vectored interrupt sources
• 8-level Priority Controller
– Source 0 is reserved for the Fast Interrupt Input (FIQ)
– Source 1 is reserved for system peripherals (RTT, PIT, EFC, PMC, DBGU, etc.)
– Other sources control the peripheral interrupts or external interrupts
– Programmable edge-triggered or level-sensitive internal sources
– Programmable positive/negative edge-triggered or high/low level-sensitive external
– Drives the normal interrupt nIRQ of the processor
– Handles priority of the interrupt sources
sources
Power Management Controller Block Diagram
MAINCK
PLLCK
MAINCK
SLCK
PLLCK
SLCK
PLLCK
Master Clock Controller
Programmable Clock Controller
/1,/2,/4,...,/64
Prescaler
USB Clock Controller
SAM7X512/256/128 Summary
/1,/2,/4,...,/64
ON/OFF
Divider
/1,/2,/4
Prescaler
Processor
Controller
Idle Mode
Clock Controller
Clock
Peripherals
ON/OFF
int
UDPCK
PCK
MCK
periph_clk[2..18]
pck[0..3]
27