STM32W108CC STMicroelectronics, STM32W108CC Datasheet - Page 21

• Manufacturer Part Number: STM32W108CC
• Description: High-performance, IEEE 802.15.4 wireless system-on-chip with embedded Flash memory
• Manufacturer: STMicroelectronics

Specifications of STM32W108CC

• Receive Current (w/ Cpu): 27 mA
• Transmit Current (w/ Cpu, +3 Dbm Tx): 31 mA
• Low Deep Sleep Current, With Retained Ram And Gpio: 400 nA/800 nA with/without sleep timer
• Standard Arm Debug Capabilities: Flash patch & breakpoint; data watchpoint & trace; instrumentation trace macrocell
• Single Voltage Operation: 2.1-3.6 V with internal 1.8 V and 1.25 V regulators

STM32W108HB STM32W108CC STM32W108CB STM32W108CZ
Table 2.
Package
Pin no.
48-Pin
26
27
28
29
Package
Pin no.
40-Pin
Pin descriptions (continued)
22
23
24
PA4
ADC4
PTI_EN
TRACEDATA2
PA5
ADC5
PTI_DATA
nBOOTMODE
TRACEDATA3
VDD_PADS
PA6
TIM1_CH3
Signal
Direction
Analog
Analog
current
Power
High
I/O
I/O
I/O
O
O
O
O
O
I
I
Doc ID 16252 Rev 13
Digital I/O
ADC Input 4. Select analog function with
GPIO_PACFGH[3:0].
Frame signal of Packet Trace Interface (PTI).
Disable trace interface in ARM core.
Select alternate output function with GPIO_PACFGH[3:0].
Synchronous CPU trace data bit 2.
Select 4-wire synchronous trace interface in ARM core.
Enable trace interface in ARM core.
Select alternate output function with GPIO_PACFGH[3:0].
Digital I/O
ADC Input 5. Select analog function with
GPIO_PACFGH[7:4].
Data signal of Packet Trace Interface (PTI).
Disable trace interface in ARM core.
Select alternate output function with GPIO_PACFGH[7:4].
Embedded serial bootloader activation out of reset.
Signal is active during and immediately after a reset on NRST.
See
Synchronous CPU trace data bit 3.
Select 4-wire synchronous trace interface in ARM core.
Enable trace interface in ARM core.
Select alternate output function with GPIO_PACFGH[7:4]
Pads supply (2.1-3.6 V)
Digital I/O
Timer 1 channel 3 output
Enable timer output in TIM1_CCER
Select alternate output function with GPIO_PACFGH[11:8]
Timer 1 channel 3 input (Cannot be remapped.)
Section 6.2: Resets on page 37
Description
Pinout and pin description
for details.
21/232