ST7263BK1 STMicroelectronics, ST7263BK1 Datasheet - Page 127

no-image

ST7263BK1

Manufacturer Part Number
ST7263BK1
Description
LOW SPEED USB 8-BIT MCU FAMILY WITH UP TO 32K FLASH/ROM, DFU CAPABILITY, 8-BIT ADC, WDG, TIMER, SCI and I2C
Manufacturer
STMicroelectronics
Datasheet

Specifications of ST7263BK1

4, 8, 16 Or 32 Kbytes Program Memory
high density Flash (HDFlash), FastROM or ROM with Read-Out and Write protection
ST7263Bxx
11.6.4
Note:
Software procedure
Refer to the control/status register (CSR) and data register (DR) in
definitions and to
ADC configuration
The total duration of the A/D conversion is 12 ADC clock periods (1/f
The analog input ports must be configured as input, no pull-up, no interrupt. Refer to the
«I/O ports» chapter. Using these pins as analog inputs does not affect the ability of the port
to be read as a logic input.
In the CSR register:
ADC conversion
In the CSR register:
When a conversion is complete:
A write to the CSR register (with ADON set) aborts the current conversion, resets the COCO
bit and starts a new conversion.
Figure 51. ADC conversion timings
Low power modes
Table 44.
The A/D converter may be disabled by resetting the ADON bit. This feature allows reduced
power consumption when no conversion is needed and between single shot conversions.
WAIT
HALT
Select the CH[3:0] bits to assign the analog channel to be converted.
Set the ADON bit to enable the A/D converter and to start the first conversion. From this
time on, the ADC performs a continuous conversion of the selected channel.
The COCO bit is set by hardware.
No interrupt is generated.
The result is in the DR register and remains valid until the next conversion has ended.
Mode
Low power modes
Figure 51
A/D Converter disabled.
After wakeup from Halt mode, the A/D Converter requires a stabilization time
before accurate conversions can be performed.
No effect on A/D Converter
ADON
HOLD
CONTROL
t
LOAD
for the timings.
Doc ID 7516 Rev 8
t
CONV
COCO BIT SET
ADCCSR WRITE
OPERATION
Description
Section 11.6.6
ADC
On-chip peripherals
=4/f
CPU
).
for the bit
127/186

Related parts for ST7263BK1