M25P80-VMP6TP Numonyx, B.V., M25P80-VMP6TP Datasheet - Page 21

• Manufacturer Part Number: M25P80-VMP6TP
• Description: 8 Mbit, low voltage, serial Flash memory with 75 MHz SPI bus interface
• Manufacturer: Numonyx, B.V.

M25P80
6.3
Table 5.
Figure 9.
Manufacturer
identification
20h
Read Identification (RDID)
The Read Identification (RDID) instruction allows to read the device identification data:
●
●
●
The manufacturer identification is assigned by JEDEC, and has the value 20h for Numonyx.
The device identification is assigned by the device manufacturer, and indicates the memory
type in the first byte (20h), and the memory capacity of the device in the second byte (14h).
The UID is set to 10h and indicates that 16 bytes, related to the CFI content, are following.
Any Read Identification (RDID) instruction while an Erase or Program cycle is in progress, is
not decoded, and has no effect on the cycle that is in progress.
The device is first selected by driving Chip Select (S) Low. Then, the 8-bit instruction code
for the instruction is shifted in. After this, the 24-bit device identification, stored in the
memory, the 8-bit Unique ID code followed by 16 bytes of CFI content will be shifted out on
Serial Data Output (Q). Each bit is shifted out during the falling edge of Serial Clock (C).
The instruction sequence is shown in
The Read Identification (RDID) instruction is terminated by driving Chip Select (S) High at
any time during data output.
When Chip Select (S) is driven High, the device is put in the Standby Power mode. Once in
the Standby Power mode, the device waits to be selected, so that it can receive, decode and
execute instructions.
Read Identification (RDID) data-out sequence
Read Identification (RDID) instruction sequence and data-out sequence
Manufacturer identification (one byte)
Device identification (two bytes)
A Unique ID code (UID) followed by 16 bytes of CFI data
Memory type
20h
Device identification
Memory capacity
Figure
14h
9.
UID
10h
CFI content
16 bytes
Instructions
21/52