EMC2302 Standard Microsystems Corp., EMC2302 Datasheet - Page 34

no-image

EMC2302

Manufacturer Part Number
EMC2302
Description
Rpm-based Pwm Fan Controller
Manufacturer
Standard Microsystems Corp.
Datasheet
Revision 1.2 (03-22-10)
2
0
0
0
0
1
1
1
1
1
0
0
1
1
DRIVE_FAIL_CNTX[1:0]
Bit 5 - NOKICKx - Determines if the Spin Up Routine will drive the fan to 100% duty cycle for 1/4 of
the programmed spin up time before driving it at the programmed level.
Bits 4 - 2 - SPIN_LVLx[2:0] - Determines the final drive level that is used by the Spin Up Routine as
shown in
Bit 1 -0 - SPINUP_TIMEx[1:0] - determines the maximum Spin Time that the Spin Up Routine will run
for (see
elapsed, then an interrupt will be generated. When the RPM-based Fan Speed Control Algorithm is
active, the fan driver will attempt to re-start the fan immediately after the end of the last spin up attempt.
The Spin Time is set as shown in
‘0’ (default) - The Spin Up Routine will drive the fan driver to 100% for 1/4 of the programmed spin
up time before reverting to the programmed spin level.
‘1’ - The Spin Up Routine will not drive the fan driver to 100%. It will set the drive at the
programmed spin level for the entire duration of the programmed spin up time.
Section
SPIN_LVLX[2:0]
Table
5.21.
4.6). If a valid tachometer measurement is not detected before the Spin Time has
1
0
0
1
1
0
0
1
1
Table 5.20 DRIVE_FAIL_CNT[1:0] Bit Decode
0
0
1
0
1
Table 5.21 Spin Level
Table
DATASHEET
Disabled - the Drive Fail detection circuitry is disabled (default)
16 - the Drive Fail detection circuitry will count for 16 update
periods
32 - the Drive Fail detection circuitry will count for 32 update
periods
64 - the Drive Fail detection circuitry will count for 64 update
periods
0
0
1
0
1
0
1
0
1
5.22.
34
NUMBER OF UPDATE PERIODS
SPIN UP DRIVE LEVEL
Dual RPM-Based PWM Fan Controller
60% (default)
30%
35%
40%
45%
50%
55%
65%
SMSC EMC2302
Datasheet

Related parts for EMC2302