DSPIC30F4013 Microchip Technology Inc., DSPIC30F4013 Datasheet - Page 125

• Manufacturer Part Number: DSPIC30F4013
• Description: Dspic30f3014/4013 High-performance, 16-bit Digital Signal Controllers
• Manufacturer: Microchip Technology Inc.

18.6.2
The 20-bit AC-Link mode allows all bits in the data time
slots to be transmitted and received but does not main-
tain data alignment in the TXBUF and RXBUF
registers.
The 20-bit AC-Link mode functions similar to the Multi-
channel mode of the DCI module, except for the duty
cycle of the Frame Synchronization signal. The AC-
Link Frame Synchronization signal should remain high
for 16 CSCK cycles and should be low for the following
240 cycles.
The 20-bit mode treats each 256-bit AC-Link frame as
sixteen, 16-bit time slots. In the 20-bit AC-Link mode,
the module operates as if COFSG<3:0> = 1111 and
WS<3:0> = 1111. The data alignment for 20-bit data
slots is ignored. For example, an entire AC-Link data
frame can be transmitted and received in a packed
fashion by setting all bits in the TSCON and RSCON
SFRs. Since the total available buffer length is 64 bits,
it would take 4 consecutive interrupts to transfer the
AC-Link frame. The application software must keep
track of the current AC-Link frame segment.
18.7
The DCI module is configured for I
a value of ‘01’ to the COFSM<1:0> control bits in the
DCICON1 SFR. When operating in the I
DCI module generates Frame Synchronization signals
with a 50% duty cycle. Each edge of the Frame
Synchronization signal marks the boundary of a new
data word transfer.
The user must also select the frame length and data
word size using the COFSG and WS control bits in the
DCICON2 SFR.
© 2007 Microchip Technology Inc.
I
2
S Mode Operation
20-BIT AC-LINK MODE
2
S mode by writing
2
S mode, the
18.7.1
The WS and COFSG control bits are set to produce the
period for one half of an I
frame length is the total number of CSCK cycles
required for a left or a right data word transfer.
The BLEN bits must be set for the desired buffer length.
Setting BLEN<1:0> = 01 produces a CPU interrupt,
once per I
18.7.2
As per the I
default, begins one CSCK cycle after a transition of the
WS signal. A ‘MSb left justified’ option can be selected
using the DJST control bit in the DCICON1 SFR.
If DJST = 1, the I
The MSb of the data word is presented on the CSDO
pin during the same CSCK cycle as the rising or falling
edge of the COFS signal. The CSDO pin is tri-stated
after the data word has been sent.
dsPIC30F3014/4013
2
S frame.
I
LENGTH SELECTION
I
2
2
2
S specification, a data word transfer, by
S FRAME AND DATA WORD
S DATA JUSTIFICATION
2
S data transfers are MSb left justified.
2
S data frame. That is, the
DS70138E-page 123