PIC10F200 Microchip Technology, Inc., PIC10F200 Datasheet - Page 18

• Manufacturer Part Number: PIC10F200
• Description: 6-Pin, 8-Bit Flash Microcontrollersfeatures 6-pin SOT-23 Packaging Precision 4 MHZ Internal Oscillator Baseline Core With 33 Instructions, 2 Stack Levels All Single-cycle Instructions Except For Program Branches Which Are Two Cycles 12-bit Wide
• Manufacturer: Microchip Technology, Inc.

PIC10F200/202/204/206
4.2
The PIC10F202/206 devices have a 10-bit Program
Counter (PC) capable of addressing a 1024 x 12
program memory space.
Only the first 512 x 12 (0000h-01FFh) for the
PIC10F202/206 are physically implemented (see
Figure 4-2). Accessing a location above these
boundaries will cause a wraparound within the first
512 x 12 space (PIC10F202/206). The effective
Reset vector is at 0000h (see Figure 4-2). Location
01FFh (PIC10F202/206) contains the internal clock
oscillator calibration value. This value should never
be overwritten.
FIGURE 4-2:
DS41239A-page 16
Note 1:
CALL, RETLW
Program Memory Organization for
the PIC10F202/206
Address 0000h becomes the
effective Reset vector. Location
01FFh contains the MOVLW XX
internal oscillator calibration value.
On-chip Program
Reset Vector
Stack Level 1
Stack Level 2
PROGRAM MEMORY MAP
AND STACK FOR THE
PIC10F202/206
PC<8:0>
Memory
512 Words
(1)
10
02FFh
0000h
01FFh
0200h
Preliminary
4.3
Data memory is composed of registers or bytes of
RAM. Therefore, data memory for a device is specified
by its register file. The register file is divided into two
functional groups: Special Function Registers (SFR)
and General Purpose Registers (GPR).
The Special Function Registers include the TMR0 reg-
ister, the Program Counter (PCL), the Status register,
the I/O register (GPIO) and the File Select Register
(FSR). In addition, Special Function Registers are used
to control the I/O port configuration and prescaler
options.
The General Purpose Registers are used for data and
control information under command of the instructions.
For the PIC10F200/204, the register file is composed of
7 Special Function Registers and 16 General Purpose
Registers (see Figure 4-3 and Figure 4-4).
For the PIC10F202/206, the register file is composed of
8 Special Function Registers and 24 General Purpose
Registers (see Figure 4-4).
4.3.1
The General Purpose Register file is accessed, either
directly or indirectly, through the File Select Register
(FSR). See Section 4.9 “Indirect Data Addressing:
INDF and FSR Registers”.
Data Memory Organization
GENERAL PURPOSE REGISTER
FILE
 2004 Microchip Technology Inc.