WM8951L Wolfson Microelectronics plc, WM8951L Datasheet - Page 31
![no-image](/images/no-image-200.jpg)
WM8951L
Manufacturer Part Number
WM8951L
Description
Stereo ADC with Microphone Input and Clock Generator
Manufacturer
Wolfson Microelectronics plc
Datasheet
1.WM8951L.pdf
(42 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
WM8951LGEFL
Manufacturer:
Panasonic
Quantity:
350
Production Data
w
3-WIRE (SPI COMPATIBLE) SERIAL CONTROL MODE
The WM8951L can be controlled using a 3-wire serial interface. SDIN is used for the program data,
SCLK is used to clock in the program data and CSB is use to latch in the program data. The 3-wire
interface protocol is shown in Figure 23.
Figure 23 3-Wire Serial Interface
Notes:
1.
2.
3.
2-WIRE SERIAL CONTROL MODE
The WM8951L supports a 2-wire serial interface. The WM8951L has one of two slave addresses that
are selected by setting the state of pin 26, (CSB).
Figure 24 2-Wire Serial Interface
Notes:
1.
2.
Table 19 2-Wire MPU Interface Address Selection
To control the WM8951L on the 2-wire bus the master control device must initiate a data transfer by
establishing a start condition, defined by a high to low transition on SDIN while SCLK remains high.
This indicates that an address and data transfer will follow. All peripherals on the 2-wire bus respond
to the start condition and shift in the next eight bits (7-bit address + R/W bit). The transfer is MSB
first. The 7-bit address consists of a 6-bit base address + a single programmable bit to select one of
two available addresses for this device (see table 24). If the correct address is received and the R/W
bit is ‘0’, indicating a write, then the WM8951L will respond by pulling SDIN low on the next clock
pulse (ACK). The WM8951L is a write only device and will only respond to the R/W bit indicating a
write. If the address is not recognised the device will return to the idle condition and wait for a new
start condition and valid address.
Once the WM8951L has acknowledged a correct address, the controller will send eight data bits (bits
B15-B8). WM8951L will then acknowledge the sent data by pulling SDIN low for one clock pulse.
SCLK
SDIN
B[15:9] are Control Address Bits
B[8:0] are Control Data Bits
CSB is edge sensitive not level sensitive. The data is latched on the rising edge of CSB.
B[15:9] are Control Address Bits
B[8:0] are Control Data Bits
SCLK
SDIN
CSB
START
CSB STATE
0
1
B15
R ADDR
B14
B13
R/W
B12
B11
ACK
B10
ADDRESS
0011010
0011011
B9
DATA B15-8
B8
B7
B6
ACK
B5
B4
DATA B7-0
PD Rev 4.1 December 2007
B3
www.DataSheet4U.com
B2
ACK
B1
WM8951
B0
STOP
31