WM8955BL Wolfson Microelectronics, WM8955BL Datasheet - Page 42

• Manufacturer Part Number: WM8955BL
• Description: Stereo DAC
• Manufacturer: Wolfson Microelectronics

w
WM8955BL
HEADPHONE OUTPUT CONFIGURATION
EARPIECE OUTPUT CONFIGURATION
The analogue outputs LOUT1/ROUT1, LOUT2/ROUT2, and OUT3 can drive a 16Ω or 32Ω
headphone load, either through DC blocking capacitors, or DC coupled without any capacitor.
Figure 30 Recommended Headphone Output Configurations
When DC blocking capacitors are used, then their capacitance and the load resistance together
determine the lower cut-off frequency, f
response. Smaller capacitance values will diminish the bass response. Assuming a 16Ω load and C1
= 220μF:
f
In the DC coupled configuration, the headphone “ground” is connected to the OUT3 pin, which must
be enabled by setting OUT3 = 1 and OUT3SW = 00. As the OUT3 pin produces a DC voltage of
AVDD/2 (=VREF), there is no DC offset between LOUT1/ROUT1 and OUT3, and therefore no DC
blocking capacitors are required. This saves space and material cost in portable applications.
It is recommended to connect the DC coupled headphone outputs only to headphones, and not to the
line input of another device. Although the built-in short circuit protection will prevent any damage to
the headphone outputs, such a connection may be noisy, and may not function properly if the other
device is grounded.
LOUT2 and ROUT2 can differentially drive a mono 32Ω earpiece as shown below.
Figure 31 Earpiece Output Connection
The right channel is inverted by setting the ROUT2INV bit, so that the signal across the earpiece is
the sum of left and right channels.
Headphone Output using DC blocking capacitors
c
= 1 / 2π R
ROUT2INV = 1
WM8955BL
L
C
1
= 1 / (2π x 16Ω x 220μF) = 45 Hz
MIXER
RIGHT
MIXER
LEFT
-1
LOUT2VOL
ROUT2VOL
c
. Increasing the capacitance lowers f
LOUT2
ROUT2
V
OUT
DC Coupled Headphone Output
= L-(-R) = L+R
(OUT3SW = 00)
PD Rev 4.1 February 2007
c
, improving the bass
Production Data
42