MT9123AE Zarlink Semiconductor, MT9123AE Datasheet - Page 4

• Manufacturer Part Number: MT9123AE
• Description: Description = Dual Voice Echo CANceller ( Itu-t G165 Compliant) ;; Package Type = Pdip ;; No. Of Pins = 28
• Manufacturer: Zarlink Semiconductor

MT9123
Pin Description (continued)
Notes:
1. All unused inputs should be connected to logic low or high unless otherwise stated. All outputs should be left open circuit when not used.
2. All inputs have TTL compatible logic levels except for MCLK, Sin and Rin pins which have CMOS compatible logic levels and PWRDN
3. All outputs are CMOS pins with CMOS logic levels.
4
19/20
27/28 CONFIG1/
Pin #
pin which has Schmitt trigger compatible logic levels.
19
20
21
22
23
24
25
26
CONFIG2
BCLK/C4i Bit Clock/ST-BUS Clock (Input). In SSI operation, BCLK pin is a 128 kHz to 4.096 MHz bit
DATA2
DATA1
Name
S2/S1
F0od
Sout
Rout
VDD
F0i
Selection of Echo Canceller A Functional States (Input).
Controllerless Mode: Selects Echo Canceller A functional states according to Table 2.
Controller Mode: S2 and S1 pins become DATA2 and DATA1 pins respectively.
Serial Data Receive (Input).
In Motorola/National serial microport operation, the DATA2 pin is used for receiving data. In
Intel serial microport operation, the DATA2 pin is not used and must be tied to Vss or Vdd.
Serial Data Port (Bidirectional).
In Motorola/National serial microport operation, the DATA1 pin is used for transmitting data. In
Intel serial microport operation, the DATA1 pin is used for transmitting and receiving data.
Delayed Frame Pulse Output (Output). In ST-BUS operation, this pin generates a delayed
frame pulse after the 4th channel time slot and is used for daisy-chaining multiple ST-BUS
devices. See Figures 5 to 8.
In SSI operation, this pin outputs logic low.
Positive Power Supply. Nominally 5 volts.
Send PCM Signal Output (Output). 128 kbit/s to 4096 kbit/s serial PCM output stream. Data
may be in either companded or 2’s complement linear PCM format. Two PCM channels are
time-multiplexed on this pin. These are the Send Out signals after echo cancellation and Non-
linear processing. Data bits are clocked out following SSI or ST-BUS timing requirements.
Receive PCM Signal Output (Output). 128 kbit/s to 4096 kbit/s serial PCM output stream.
Data may be in either companded or 2’s complement linear PCM format. Two PCM channels
are time-multiplexed on this pin. This output pin is provided for convenience in some
applications and may not always be required. Data bits are clocked out following SSI or ST-
BUS timing requirements.
Frame Pulse (input). In ST-BUS operation, this is a frame alignment low going pulse. SSI
operation is enabled by connecting this pin to Vss.
clock. This clock must be synchronous with ENA1, ENA2, ENB1 and ENB2 enable strobes.
In ST-BUS operation, C4i pin must be connected to the 4.096MHz (C4) system clock.
Device Configuration Pins (Inputs). When CONFIG1 and CONFIG2 pins are both logic 0,
the MT9123 serial microport is enabled. This configuration is defined as Controller Mode.
When CONFIG1 and CONFIG2 pins are in any other logic combination, the MT9123 is
configured in Controllerless Mode. See Table 3.
Description
Data Sheet