MPC89L51A Megawin Technology, MPC89L51A Datasheet - Page 19

• Manufacturer Part Number: MPC89L51A
• Description: 8-bit micro-controller
• Manufacturer: Megawin Technology

www.DataSheet4U.com
Baud-Rate Generator Mode (BRG)
Timer2 can be configured to generate various baud-rate. Bits TCLK and/or RCLK in T2CON
allow the serial port transmit and receive baud rates to be derived from either Timer1 or Timer2.
When TCLK=0, Timer1 is used as the serial port transmit baud rate generator. When TCLK=1,
Timer2 is used as the serial port transmit baud rate generator. RCLK has the same effect for the
serial port baud rate. With these two bits, the serial port can have different receive and transmit
baud rates – one generated from Timer1 and the other from Timer2.
In BRG mode, Timers is operated very like auto-reload up-only mode except that the T2EX pin
cannot control reload.
Timer2, but TF2 will not be set. A 1-to-0 transition on P2EX pin can set EXF2 to request interrupt
service if EXEN2=1.
The baud rate in UART Mode1 and Mode3 are determined by Timer2’s overflow rate given
below:
MEGAWIN
OSC/12
T2 pin
T2EX pin
C//T2
Baud Rate =
Baud Rate =
TR2
0
1
[32 x [65536 – (RCAP2H, RCAP2L) ] ]
An overflow on Timer2 will load RCAP2H, RCAP2L contents onto
Timer2 overflow rate
EXEN2
0
1
Oscillator Frequency
16
MPC89x51A Data Sheet
EXF2
RCAP2L[7:0]
TL2[7:0]
Timer2 interrupt
RCAP2H[7:0]
TH2[7:0]
(counting T2EX)
“1”
“1”
(as a timer)
Timer1 overflow
“0”
“0”
2
“0” “1”
TCLK
RCLK
16
TX Clock
SMOD
RX Clock
16
19