MPC89L51A Megawin Technology, MPC89L51A Datasheet - Page 23

• Manufacturer Part Number: MPC89L51A
• Description: 8-bit micro-controller
• Manufacturer: Megawin Technology

www.DataSheet4U.com
SFR: WDTCR (Watchdog Timer Control):
ENW: Enable WDT while it is set. ENW cannot be cleared by firmware.
CLRW: Clear WDT to recount while it is set. Hardware will automatically clear this bits.
WIDL: Set this bits to disable WDT generating reset even though the μC is in idle mode.
{PS2, PS1, PS0}: select the pre-scalar output.
Serial IO Port (UART)
The serial port of MPC89x51A is duplex. It can transmit and receive simultaneously. The
receiving and transmitting of the serial port share the same SFR SBUF, but actually there are
two SBUF registers implemented in the chip, one is for transmitting and the other is for receiving.
The serial port can be operated in 4 different modes.
Mode 0
Generally, this mode purely is used to extend the I/O features of this device.
Operating under this mode, the device receives the serial data or transmits the serial data via pin
RXD, while there is a clock stream shifted via pin TXD which makes convenient for external
synchronization. An 8-bits data is serially transmitted/received with LSB first. The baud rate is
fixed at 1/12 the oscillator frequency.
Mode1
A 10-bitsdata is serially transmitted through TXD or received through RXD. The frame data
includes a start bits (0), 8 data bits and a stop bits (1). After the receiving, the device will keep the
stop bits in RB8 which from SRF SCON.
MEGAWIN
Bits-7
-
{1, 1, 1}: = set the pre-scaling value 256
1: = enable watchdog timer, 0: = does not use watchdog timer
{0, 0, 0}: = set the pre-scaling value 2
{0, 0, 1}: = set the pre-scaling value 4
{0, 1, 0}: = set the pre-scaling value 8
{0, 1, 1}: = set the pre-scaling value 16
{1, 0, 0}: = set the pre-scaling value 32
{1, 0, 1}: = set the pre-scaling value 64
{1, 1, 0}: = set the pre-scaling value 128
Bits-6
Baud Rate (for Mode 1)
-
Bits-5
ENW
or =
=
MPC89x51A Data Sheet
CLRW
Bits-4
(Timer-2 overflow rate)
2
SMOD
32
Bits-3
WIDL
16
X
(Timer-1 overflow rate)
Bits-2
PS2
Bits-1
PS1
Bits-0
PS0
23