S-24CS08A Seiko Instruments, S-24CS08A Datasheet - Page 20

• Manufacturer Part Number: S-24CS08A
• Description: (S-24CS0xA) 2-Wire CMOS Serial EPROM
• Manufacturer: Seiko Instruments

www.DataSheet4U.com
20
2-WIRE CMOS SERIAL E
S-24CS01A/02A/04A/08A
Precautions
I
● Generally, an E
● Do not apply an electrostatic discharge to this IC that exceeds the performance ratings of the built-in
● SII claims no responsibility for any and all disputes arising out of or in connection with any infringement of
Purchase of I
Rights to use these components in an I
Standard Specification as defined by Philips.
Please note that a product or a system incorporating this IC may infringe upon the Philips I
depending upon its configuration. In the event of such infringement Seiko Instruments Inc., shall not bear
any responsibility for any matters with regard to and arising from such patent infringement.
2
C Bus License
ON/OFF. The S-24CS01A/02A/04A/08A initialize themselves by the power on clear circuit at power on.
Attention should be paid to the followings so as to operate the power on clear circuit correctly, otherwise
malfunction may occur.
electrostatic protection circuit.
the products including this IC upon patents owned by a third party.
1. All input and output pins should be connected to the V
2. Raise the power voltage up to the operation voltage from 0 V without staying at middle range.
3. Raising speed of the power voltage should be faster than 40 ms/V.
4. Power off interval before power on should be longer than 100 ms.
2
C components of Seiko Instruments Inc., conveys a license under the Philips I
2
PROM may cause a malfunction by the operation in low voltage range induced by power
2
PROM
2
C system, is granted provided that the system conforms to the I
Seiko Instruments Inc.
CC
or the GND level so as not to be floating.
2
C Patent Rights
Rev.2.0
2
C Patent.
_10
2
C