MT9046 Zarlink Semiconductor, MT9046 Datasheet - Page 5

no-image

MT9046

Manufacturer Part Number
MT9046
Description
T1/E1 System Synchronizer with Holdover
Manufacturer
Zarlink Semiconductor
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MT9046AN
Manufacturer:
ZARLINK
Quantity:
119
Part Number:
MT9046AN
Quantity:
100
Part Number:
MT9046AN
Manufacturer:
ZARLINK
Quantity:
20 000
Part Number:
MT9046AN1
Manufacturer:
LT
Quantity:
1 500
Part Number:
MT9046AN1
Manufacturer:
ZARLINK
Quantity:
10 000
Part Number:
MT9046AN1
Manufacturer:
ZARLINK
Quantity:
20 000
Part Number:
MT9046ANR1
Manufacturer:
TI
Quantity:
5 544
Functional Description
The MT9046 is a Multitrunk System Synchronizer with frequency holdover capability, providing timing (clock) and
synchronization (frame) signals to interface circuits for T1 and E1 Primary Rate Digital Transmission links. Figure 1
is a functional block diagram which is described in the following sections.
Reference Select MUX Circuit
The MT9046 accepts two simultaneous reference input signals and operates on their falling edges. Either the
primary reference (PRI) signal or the secondary reference (SEC) signal can be selected as input to the TIE
Corrector Circuit. The selection is based on the Control, Mode and Reference Selection of the device. See Table 1
and Table 4.
Frequency Select MUX Circuit
The MT9046 operates with one of four possible input reference frequencies (8 kHz, 1.544 MHz, 2.048 MHz or
19.44 MHz). The frequency select inputs (FS1 and FS2) determine which of the four frequencies may be used at
the reference inputs (PRI and SEC). Both inputs must have the same frequency applied to them. A reset (RST)
must be performed after every frequency select input change. See Table 1.
Time Interval Error (TIE) Corrector Circuit
The TIE corrector circuit, when enabled, prevents a step change in phase on the input reference signals (PRI or
SEC) from causing a step change in phase at the input of the DPLL block of Figure 1.
During reference input rearrangement, such as during a switch from the primary reference (PRI) to the secondary
reference (SEC), a step change in phase on the input signals will occur. A phase step at the input of the DPLL
would lead to unacceptable phase changes in the output signal.
Pin Description (continued)
Pin #
45
46
47
48
Name
TRST
TMS
TCK
TDI
Test Serial Data In (Input). JTAG serial test instructions and data are shifted in on this pin.
This pin is internally pulled up to V
Test Reset (Input). Asynchronously initializes the JTAG TAP controller by putting it in the
Test-Logic-Reset state. If not used, this pin should be held low.
Test Clock (Input): Provides the clock to the JTAG test logic. This pin is internally pulled up to
V
Test Mode Select (Input). JTAG signal that controls the state transitions of the TAP
controller. This pin is internally pulled up to V
DD
.
FS2
0
0
1
1
Table 1 - Input Frequency Selection
FS1
0
1
0
1
Zarlink Semiconductor Inc.
MT9046
DD
5
.
Input Frequency
Description
19.44 MHz
1.544 MHz
2.048 MHz
DD
8 kHz
.
Data Sheet

Related parts for MT9046